Optical system with a medium different from air

AI Thread Summary
The discussion revolves around an optical system where a cuvette filled with water affects the light spot observed on a sensor. Initially, inserting an empty cuvette results in an attenuated light spot, indicating that the plastic's refractive index does not significantly alter the spot size. However, when the cuvette is filled with water, the light spot visibly broadens, contradicting the expectation that a higher refractive index would lead to better focusing. Participants note that the behavior of light depends on the lens's focal point and the specific optical properties of the materials involved. The conversation highlights the complexities of light behavior in different media and the importance of understanding refractive indices in optical systems.
Frank-95
Messages
51
Reaction score
1
Hi all!

I have an optical system made up like this:

Circular led source -> smaller circular diaphragm -> circular even smaller lens -> cmos sensor at the posterior focal plane

This is the in scale model:
AAA.png


The image is optically after the focal plane, but practically it will lie on it due to the sensor.

Now what happens is this.
Firstly I insert an empty cuvette between the led and the diaphragm. The cuvette fills completely the gap, and is 12mm and it is made by 1 mm of plastic per side.

What I see upon the sensor is the same light spot, attenuated though. This means that the real part of the plastic refraction index, and/or the small plastic width light has to pass through, is not high enough to see size changes in the spot. The imaginary part is, though, since I can see an attenuation.

Then I fill the cuvette with water, so that I have 1 mm plastic, 10 mm water, 1 mm plastic. What I see in the sensor is a visible widening of the spot.
At first I thought it was because of double refraction rays movement, but then I realize that since water index is greater than air one, rays should focus better than air so the spot should be smaller.

Why does the light spot broads when the light passes though water?

Thank you very much.
 
Science news on Phys.org
Why do you say that greater index of refraction should focus better? It depends on the focal point of the lens.
 
I would like to use a pentaprism with some amount of magnification. The pentaprism will be used to reflect a real image at 90 degrees angle but I also want the reflected image to appear larger. The distance between the prism and the real image is about 70cm. The pentaprism has two reflecting sides (surfaces) with mirrored coating and two refracting sides. I understand that one of the four sides needs to be curved (spherical curvature) to achieve the magnification effect. But which of the...
Back
Top