Software to Simulate a Renewable Grid with ML

AI Thread Summary
The discussion centers on seeking software for simulating a renewable energy grid using machine learning. Participants suggest exploring resources like a PF Insights article for insights on renewable energy and grid operations. One user mentions not finding specific software but appreciates the article's valuable information. Another suggests checking out AspenTech's Digital Grid Management suite as a potential fit for the simulation needs. Overall, the conversation highlights the challenge of finding suitable software while sharing helpful resources.
mhr005
Messages
2
Reaction score
1
TL;DR Summary
Looking software to simulate a renewable grid that has re-enforement/unsupervised learning integration
Hello, I am currently working on a paper that reqires me to simulate a renewable energy grid with machine learning. I'd be grateful if anyone with experience on this can give a few suggestion as to which software to use for this task. Thanks in advance.
 
Engineering news on Phys.org
This sounds like something you might have to write yourself.
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Battery sizing in systems for power grid frequency regulation?
Replies
1
Views
1K
Self excited induction generators and grid connected solar inverters?
Replies
9
Views
2K
Ground loop on electronic audio systems
Replies
28
Views
755
Maxwell Linear Generator (Input Power < Output Power and losses?)
Replies
2
Views
615
Why the fascination with intermittent renewable energy sources?
Replies
35
Views
7K
Troubleshooting a problem with a 30-Bus grid with Powerwolrd simulator
Replies
2
Views
3K
Why Might a Halbach Array Simulation Differ from Actual Measurements?
Replies
8
Views
3K
Project help 'Power quality in renewable energy systems'
Replies
1
Views
2K
ABC reference frame synchronous generator modelling in Ltspice
Replies
1
Views
3K
Constructing a mini grid for senior project
Replies
1
Views
2K

Hot Threads

Recent Insights

Back
Top