Solve Max Velocity Increase of 100kg Probe in Gravity Assist from Mars

  • Thread starter Thread starter zebra1707
  • Start date Start date
AI Thread Summary
The discussion focuses on calculating the maximum velocity increase of a 100 kg space probe during a gravity assist maneuver around Mars. The initial calculation suggests a maximum increase of 60,400 m/s based on conservation of momentum and kinetic energy principles. However, the conversation highlights the need to adjust the probe's velocity relative to Mars rather than the Sun for accurate results. Additionally, the impact of a 120-degree arc on the probe's velocity change is explored, suggesting the use of momentum equations and vector diagrams for a more precise calculation. The maximum change in speed for a passive Mars gravity assist is noted to be approximately 3.5 km/s, emphasizing the complexity of gravitational maneuvers.
zebra1707
Messages
106
Reaction score
0

Homework Statement



I have a question which asks for the maximum increase in velocity that can be achieved by a 100 kg space probe traveling at 12 000 ms -1, in a gravity assist manoeuvre around the planet Mars, which has an orbital velocity of 24200 ms -1.

Homework Equations



vf = vi + 2vi
= 12000 + 2(24200)
= 60400, therefore max increase in velocity is 60400 ms -1

The Attempt at a Solution



See above. The next part asks how would your answer be if the probe only completed 120 degree arc in its flyby? Support with vector diagram.

You are not told what the original arc is, so I assume it is greater than 120 degrees. However, that does not assist with the answer to this problem?

If I draw the Before and After vectors diagrams and resultant incoming and outgoing velocities relative to the planet by using pythag - but I am still no closer to a solution.
 
Last edited:
Physics news on Phys.org
You have gotten the speeds mixed up. First note, that the speeds are (I assume) given relative to the sun and that the speeds in the first equation should be relative to the planet (mars), so you should transform the speed for the probe to be relative to the planet (by coincidence this also gives 12 km/s). Second, the initial and final speed in the equation refer to that of the probe, not the planet. Third, the text ask for the change in speed (vf minus vi).

If you are given an arc (angle between initial and final velocity vector) you also need another formula that contains this angle (or you need to derive it from geometry), but its difficult to provide help without knowing a bit more about what you have been given.
 
The question is as stated no additional information.

Formula comes from
1. Applying the conservation of momentum to this collision KVi - vi = KVf + vf
2. Applying the conservation of kinetic energy KVi^2 + vi^2 = KVf^2 + vf^2

Solving equations simultaneously for vf leads to the following equation:

vf = vi + 2Vi

where: vf = maximum exit velocity of spacecraft ms -1
vi = entry velocity of spacecraft - relative to the sun (12000 ms -1)
Vi = velocity of the planet (in this case Mars - 24 200 ms -1)

Therefore vf = 12,000 + 2(24 200)
= 60 400 ms -1

Therefore this is the max increase in velocity is 60 400 ms -1. The question then asks what would the answer be if the probe only completed 120 degree of arc in this fly by (support with vector diagram).
 
Last edited:
OK, ignoring for a minute how mind-numbing unrealistic this "collision" is, the change in speed in first case must be vf-(-vi), that is, a tad more than vf.

To calculate how much speed changes if the initial velocity is only turned 60 degrees (instead of 180), you could reformulate the momentum equation by looking only at the momentum projected onto one particular direction and then solve this equation together with the kinetic energy equation as before. For instance, if you draw the velocities before and after in a diagram with the planet velocities parallel to the x-axis, you could write an equation for conservation of momentum onto the x-axis. You can probably apply some assumptions along the way to simplify the calculations. Alternatively, you could look up how to calculate the final speeds in a two-dimensional elastic collision and apply this to your problem.

I must admit that I originally thought the problem text were concerned with real gravitational sling-shot maneuvers. If it were, it would be instructive to know that the maximum change in speed for a passive Mars gravity assist is around 3.5 km/s, and can be calculated as

\Delta v = 2 v_\infty \sin(\varphi / 2)

where v_\infty is the hyperbolic excess speed and \varphi is the rotation of the velocity vector which depends on the minimum distance the probe passes by the planet center (this is the equation I thought you referred to originally, just with the rotation angle set to 180 deg). Setting the minimum distance to the planet radius for Mars and finding the hyperbolic excess speed which maximizes change of speed gives the mentioned value of 3.5 km/s for mars.
 
Thank you Filip for your assistance. Now this makes sense.

CHeers P
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top