- #1
alexgmcm
- 77
- 0
I am confused over how to work with errors and uncertainties.
So far when dealing with a small number of measurements I have used the partial derivative method to calculate the final error in my result e.g. if my result is
[tex]
E=mgh \text{ then assuming no error in g my uncertainty is } \Delta E = \sqrt{\left|\frac{\delta E}{\delta m} \right| ^2 \cdot \Delta m ^2 + \left|\frac{\delta E}{\delta h} \right| ^2 \cdot \Delta h^2}
[/tex]
and when dealing with a large number of measurements (normally when the experiment has computerised data acquisiton) I use the standard error:
[tex]SE = \frac{s}{\sqrt{n}} [/tex]
where n is the number of measurements and s is the standard error (calculated using Bessel's correction which makes it work for smaller N by some mathematical trickery):
[tex]s=\sqrt{\frac{1}{N-1} \Sigma^{N}_{i=1} (x_i - \bar{x})^2}[/tex]
This has always seemed strange to me as N is therefore usually the same as n which just seems weird. I guess I'm doing it wrong but I am not sure how?
How should errors be treated both in the case when you have a small number of measurements of each variable a statistical approach is impossible, and when you have a large number of results and a statistical approach is more attractive?
Any help or advice would be greatly appreciated,
Alex.
So far when dealing with a small number of measurements I have used the partial derivative method to calculate the final error in my result e.g. if my result is
[tex]
E=mgh \text{ then assuming no error in g my uncertainty is } \Delta E = \sqrt{\left|\frac{\delta E}{\delta m} \right| ^2 \cdot \Delta m ^2 + \left|\frac{\delta E}{\delta h} \right| ^2 \cdot \Delta h^2}
[/tex]
and when dealing with a large number of measurements (normally when the experiment has computerised data acquisiton) I use the standard error:
[tex]SE = \frac{s}{\sqrt{n}} [/tex]
where n is the number of measurements and s is the standard error (calculated using Bessel's correction which makes it work for smaller N by some mathematical trickery):
[tex]s=\sqrt{\frac{1}{N-1} \Sigma^{N}_{i=1} (x_i - \bar{x})^2}[/tex]
This has always seemed strange to me as N is therefore usually the same as n which just seems weird. I guess I'm doing it wrong but I am not sure how?
How should errors be treated both in the case when you have a small number of measurements of each variable a statistical approach is impossible, and when you have a large number of results and a statistical approach is more attractive?
Any help or advice would be greatly appreciated,
Alex.