Electrical Unused light switch in the living room?

  • Thread starter Thread starter arabianights
  • Start date Start date
AI Thread Summary
An unused light switch in a living room may not be truly inactive, as it could control an outlet instead of a light fixture. To determine its function, check for wires behind the faceplate without removing the switch. Nearby outlets should be tested with a socket tester or lamp to see if they are controlled by the switch. It's common for outlets to have split functionality, where one part is always live and the other is switch-controlled. Investigating with a wire detector can provide further clarity on the switch's purpose.
arabianights
Messages
65
Reaction score
8
hi guys

I have a switch mounted on the wall in my living room that doesn't control anything, it's on the opposite side of stairwell to the basement and below the HVAC vent. the light switch to stairwell is in the same space of stairs. and the living room ceiling light is controlled on the far side near the kitchen.

the townhouse was built by Pulte in the mid 80s if that helps.
 
Physics news on Phys.org
How do you know it is unused? When you pull the plastic faceplate off, do you see any wires going to the switch? (Don't pull the switch itself out of the wall.)

Oftentimes, such a switch will control an outlet, so that a floor lamp can be controlled via the wall switch. Are there any outlets nearby? Can you use a socket tester or even just a lamp to test to see whether the switch is controlling it?
 
  • Like
Likes DaveE, Lnewqban, BillTre and 1 other person
It's not uncommon for a receptacle to be split. For instance the bottom may be live all the time but the top is controlled by the switch.
 
  • Like
  • Informative
Likes OmCheeto, DaveE, BillTre and 2 others
First thing I would do would be to check it with a wire detector (few bucks for a basic model).
 
My last house had a switch that controlled a louver to the upstairs HVAC so you could shut it in the summer when the upstairs got too hot.
 
Since it's a town house, you might try asking your neighbors if they have one too and what it does.
 
  • Like
Likes OmCheeto and berkeman
Some time ago I posted this Raspberry PI DIY Mass Spec using Raman Scattering. It's was something of a cumbersome project though, needing a 3D printer and special heat-resistant plastic giving of carcinogenic fumes during printing. To be blunt it was also not very mobile and interpreting the results was further cumbersome Recently though, I've been told that Arduino, and it's various sensor packages, has matured to the point where it's a usable alternative. Now I realize that a cigarette...
Thread 'Nonlinear rubberband type thing - "k" dropping fast as it is stretched'
What materials can I try in order to get a curve of displacement versus force that looks somewhat like this.. (of course, there would be a small kink around the origin where the ends of the rubberband are closer together than its length, which is not shown here). I am looking for something that will last at least 100 stretch cycles and is not messy, so for example liquid based colloidal stuff won't be suitable. Is there something one can whip up using silicone and some additive, say? Or...
Back
Top