What is the Significance of Half Crest Time in Power Transformer Data Sheets?

Thread starter ironsword
Start date Mar 21, 2015
Tags

Time Transformer

AI Thread Summary

Half crest time, noted as 0.8 seconds in power transformer data sheets, refers to the duration it takes for the inrush current to reach half of its peak value. This measurement is crucial as it impacts the transformer's ability to handle transient conditions without damage. Understanding half crest time helps in assessing the transformer's performance during startup and fault conditions. It is essential for ensuring the reliability and longevity of the transformer. Further research on this term can provide deeper insights into its significance in transformer specifications.

Mar 21, 2015

ironsword

Dears,
during reading power transformer (0.71/33) kv data sheet, I found term "half crest time" which equals to 0.8 s,
the question is: what is that time and why is important?
thanks and kind regards.

Engineering news on Phys.org

Mar 21, 2015

anorlunda

Staff Emeritus

Science Advisor

Homework Helper

Insights Author

It has to do with inrush current. I googled the phrase and found 8 references that can give you more detail.

Mar 21, 2015

ironsword

thank you Anorlunda

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...

View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...

View full post »

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...

View full post »