Who Else Is Needed for Constructing High-Rise Buildings?

  • Thread starter Thread starter physics2k
  • Start date Start date
  • Tags Tags
    Building
AI Thread Summary
Constructing high-rise buildings requires a diverse team of professionals, including structural engineers, architects, civil engineers, and specialized mechanical and electrical engineers. Architects focus on design and layout, ensuring aesthetic appeal and functionality, while engineers ensure structural integrity and compliance with safety regulations. Knowledge of local building codes and historical performance of construction techniques is crucial. For those seeking expertise, consulting with local professionals in the industry is recommended. A mechanical engineer specializing in building construction, particularly HVAC, is essential during the consultation phase.
physics2k
Messages
10
Reaction score
0
hi,

i assume this would be a structural engineer or an architect.

i assume that an architect would have to have a good understanding of physics, especially when designing large buildings.

i assume that there are regulations based on the historical performance of various construction techniques and that there are geographical variations.

what other disciplines would have the expertise to offer advice in the construction of buildings over 20 floors in height?
 
Engineering news on Phys.org
civil engineers, mechanical engineers specializing in building construction, electrical engineers for the electrical circuits, HVAC engineers -

You're going to want a team of people.

From my (fairly limited with this topic - it's been almost a decade since I last worked with them) experience, the architects plan the layouts to make sure the floorplans make sense and the building looks nice. The engineers make sure it won't fall down. An architect with a lot of relevant experience may have a 'gut feel' for it, but it will be an engineer or an engineering company which signs off on the design.
 
Thank you ever so much for your reply.
From your answer it seems that I'm looking for a mechanical engineer specializing in building construction.
I'm just at the consultation stage so I won't need the team just yet.

So where might I find a mechanical engineer on this board?
 
I'm a mechanical (HVAC) engineer, but if I were in your position I would contact someone in the industry in your local area.
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top