Wind & TV Reception: Does Wind Impact Signal?

  • Thread starter Thread starter techmologist
  • Start date Start date
  • Tags Tags
    Wind
AI Thread Summary
Wind can affect TV reception primarily by misaligning antennas or obstructing signals with physical objects like trees. Regular air currents do not significantly disrupt radio waves, but ionized air during thunderstorms can interfere with both satellite and tower-generated signals. Disturbances in the ionosphere, caused by solar activity or atmospheric changes, can impact signal propagation, particularly for long-distance communications like Ham radio. However, for typical TV reception, which relies on signals from nearby towers, the main concern is ordinary weather rather than ionospheric effects. Understanding these factors is crucial for optimizing TV signal reception.
techmologist
Messages
305
Reaction score
12
Can wind disrupt TV reception in any way other than the two most obvious ways: 1) blowing the receiving antenna out of alignment, and 2) blowing obstacles like trees into the path of the signal? I would think the actual air currents would be invisible to the radio waves...am I wrong?
 
Engineering news on Phys.org
Regular air will not interact much with radio waves no matter how much it blows around. Ionized air... not that's another story. For instance, "storms" in the ionosphere will interfere with satellite signals trying to get through. And the charged state of the atmosphere during thunderstorms can interfere with reception of tower-generated signals.
 
Yes, I had tower-generated signals in mind. I don't know anything about it, but I have read that disturbances in the ionosphere can affect signal propagation. I really need to learn more about this stuff. Thanks.

EDIT: And yes, it makes sense that thunderstorms can create charged air currents that are also electrical currents.
 
The effect of the atmosphere depends on how far away you are from the broadcast tower. I am not an engineer, but I think typically TV towers are built close enough that you are getting the signal right from the tower. Whereas Ham radio at large distances relies on reflections off of the ionosphere. So Ham Radio would be more sensitive to ionosphere disturbances. Ionospheric "whether" is different than the whether we are used to near the surface of the earth. Ionospheric disturbances are caused by solar flares, or the transition at sunset, etc.
 
That makes a lot of sense. TV stations should be within 100 miles or less, so the signal can reach your rooftop antenna in a straight shot without being affected by the ionosphere. So only ordinary (troposphere?) weather need be considered. Thank you for the explanation.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top