Wood Shield For Magnetic Field?

AI Thread Summary
The discussion centers on the use of wood to encase the compass in the V-1 terror drone, which was initially affected by magnetic interference from the metal chassis. Participants clarify that the compass was likely a magnetic compass, and the wooden shell served as a spacer and non-ferrous enclosure to reduce interference rather than block magnetic field lines. The use of lighter materials like wood and duralumin was preferred over steel to minimize magnetic influences on the compass. The V-1's guidance system relied on a gyrocompass, which maintained orientation based on feedback from the magnetic compass. Overall, the consensus is that the wood's role was to mitigate interference rather than act as a shield against magnetic fields.
Hexogen
Messages
3
Reaction score
0
So, I was watching PBS's Nazi Mega Weapons, and they were discussing the V-1 terror drone when they said something that made me scratch my head. They said that the Nazis initially had problems with the compass that facilitated navigation because of magnetic interference from the metal in the V-1 chassis. The part that confused me is that they solved this problem by encasing the compass in a wooden shell. I didn't think that an insulator could stop magnetic field lines. In fact, I'm pretty sure of it, unless we can make monopoles now. Any speculation on how this worked, or if the show meant something else when they said this?
 
Physics news on Phys.org
Are you sure the wood was a shield? My interpretation of what you wrote would be that the part of the shell of the drone that surrounded the compass was made of wood so that the compass was outside the metal chassis, yet still securely attached to it. ie the wood was to put the compass where the metal chassis wouldn't shield the compass from the Earth's magnetic field.
 
  • Like
Likes Hexogen and berkeman
Maybe the metal was blocking the Earth's magnetic field and the use of wood allowed the compass to work properly.
 
  • Like
Likes berkeman
Hexogen said:
PBS's
Hexogen said:
if the show meant something else
Consider the source; consider the number of different conflicts in which the source has sunk HMS Barham. Ignore source soundtrack and examine raw footage.
 
Hexogen said:
I didn't think that an insulator could stop magnetic field lines.

You don't want to "stop magnetic field lines" from reaching the compass, right? :wink:
 
Hexogen said:
So, I was watching PBS's Nazi Mega Weapons, and they were discussing the V-1 terror drone when they said something that made me scratch my head. They said that the Nazis initially had problems with the compass that facilitated navigation because of magnetic interference from the metal in the V-1 chassis. The part that confused me is that they solved this problem by encasing the compass in a wooden shell. I didn't think that an insulator could stop magnetic field lines. In fact, I'm pretty sure of it, unless we can make monopoles now. Any speculation on how this worked, or if the show meant something else when they said this?
IDK what this program was talking about, but the V-1 was guided by an on-board gyrocompass, which is not the same thing as a magnetic compass.

https://en.wikipedia.org/wiki/V-1_flying_bomb#Guidance_system

A gyrocompass works by spinning up a disk to a very high speed, so much so that the disk maintains its original orientation even though the vehicle carrying it may be moving about.

https://en.wikipedia.org/wiki/Gyrocompass

Gyros are used to guide all sorts of vehicles, from aircraft to ships to missiles, etc.

The V-1 guidance system was crude and only allowed the craft to fly on a heading set before launch. The range to the target was counted down by a spinner in the nose which cut off fuel to the ramjet when the missile had traveled the required distance. The V-1 then dived unpowered into the target after that point.
 
  • Like
Likes Hexogen
Steamking. The gyroscope remained true on the basis of feedback received from a magnetic compass. found that on your wiki page link =)
 
Wouldn't the wooden frame create extra distance between the compass and the metal rocket ? That would surly decrease the magnetic interference. It would probably help somewhat with vibrations to I'm guessing?
 
Last edited:
Google found a description..

http://www.zenza.se/vw/

In the front of the war head is a light-alloy fairing with a detachable nose cap built of the same material. The object of using duralumin at this point is to keep down magnetic influences, since the magnetic compass is carried in the nose. The compass can be pre-set to guide the aircraft on the desired course; it is carried in a large bowl-shaped wooden receptacle.

So basically they used wood/duralumin instead of steel because steel would affect the compass. Wood/duralumin is also lighter than steel

There is actually a photo of the wooden cover for the V1 compass on this page. Sorry I can't link direct to the photo. Search the page for "V1 wooden nose"

http://spitfirespares.co.uk/Rockets 1.html
 
  • Like
Likes Hexogen
  • #10
Emerging consensus is that it functioned as a spacer and non-ferrous enclosure, rather than any kind of "blocking" which seems to make sense, but is an oddly disappointing answer somehow.
 

Similar threads

Back
Top