Maximum range (RFID) can function

AI Thread Summary
The maximum range of RFID devices varies by manufacturer and is influenced by several factors. Key limitations include the strength of the RF signal, which is regulated by government bodies like the FCC, and the power available for transmission. Additionally, the gain of the receiving antenna and the sensitivity of the receiving circuit play crucial roles in determining range. Multi-path interference can further degrade signal quality, especially over longer distances. For accurate range specifications, consulting multiple manufacturers is recommended.
banerjeerupak
Messages
122
Reaction score
1
I need to know the maximum range in which a radio frequency identification device (RFID) can function. What is it limited by?
 
Engineering news on Phys.org
The max range will vary by device.
The manufacturer should be able to supply this info.
 
Eighteen astronomical units.

- Warren
 
chroot said:
Eighteen astronomical units.

- Warren

:smile::smile::smile:
 
banerjeerupak said:
I need to know the maximum range in which a radio frequency identification device (RFID) can function. What is it limited by?

The range is limited by two basic factors. First, there will generally be some limitation on how strong of an RF signal can be used. The limitations may come in the form of government limits (like by the FCC here in the US), in order to limit RF interference with other RF devices in nearby frequency bands. Or the limitations may come in the form of how much power is available for transmission, or how (in)efficient a small transmit antenna may be, etc.

The second factor is the gain of the receive antenna and the sensitivity of the receive circuit, along with the efficiency of the receive processing string. RFID and ISM band low-noise receivers have improved over the past few years, so as NoTime says, you will need to check with several manufacturers of systems to see what kind of range they are claiming.

BTW, in addition to those two basic range-limiting factors, you also have the issue of multi-path interference, which further degrades the transfer of energy. The farther you want to go, the more multipath interference will become a hindrance.


(EDIT: fixed GSM --> ISM)
 
Last edited:
plenty of information i see.
i'll have to analyse if before i say anything or ask furhter
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
Back
Top