- #1
shiju.joseph
- 1
- 0
Hi frnds,
I have the photodiode DET10A and I am trying to take its output to computer using USB-6008. Labview feels that the DAQ’s ports are open and shows values 1.4 – 1.42. However, when I connect the photodiode to a multimeter or oscilloscope I see correct signal. the maximum photodiode output voltage for my measurement is 1.05 V.
What should I connect to the output end of the photodiode in order to get voltage measurement at the DAQ’s port.
Thank you very much
With regards
Shiju
I have the photodiode DET10A and I am trying to take its output to computer using USB-6008. Labview feels that the DAQ’s ports are open and shows values 1.4 – 1.42. However, when I connect the photodiode to a multimeter or oscilloscope I see correct signal. the maximum photodiode output voltage for my measurement is 1.05 V.
What should I connect to the output end of the photodiode in order to get voltage measurement at the DAQ’s port.
Thank you very much
With regards
Shiju