- #1
designchick
- 15
- 0
Hi gurus,
I was hoping you guys can help me with a little something:
I have just purchased a 12V DC motor with a shaft diameter of 5.4mm
(Oddly enough, the description on the ebay page says 5.5mm, but the technical drawing
attached, says that its 5.4mm).
In any case - i am looking for a gear that i can attach onto this motor. However, all the gears out there have their measurements in imperial.
My question is: What bore diameter should i be looking for to attach to my motor, that has a 5.4 - 5.5mm shaft? 3/8" seems slightly too big, and 5/16" seems a little too large.
Any suggestions?
(Sorry if this seems like a silly question)
Thanks!
I was hoping you guys can help me with a little something:
I have just purchased a 12V DC motor with a shaft diameter of 5.4mm
(Oddly enough, the description on the ebay page says 5.5mm, but the technical drawing
attached, says that its 5.4mm).
In any case - i am looking for a gear that i can attach onto this motor. However, all the gears out there have their measurements in imperial.
My question is: What bore diameter should i be looking for to attach to my motor, that has a 5.4 - 5.5mm shaft? 3/8" seems slightly too big, and 5/16" seems a little too large.
Any suggestions?
(Sorry if this seems like a silly question)
Thanks!