- #1
Physicist3
- 104
- 0
Hi, I've read that the max length of UTP and STP cable segments is 100m? Does this mean that a repeater is required after every signle cable segment?
Physicist3 said:Hi, I've read that the max length of UTP and STP cable segments is 100m? Does this mean that a repeater is required after every signle cable segment?
wikipedia said:Maximum cable segment length
According to the ANSI/TIA/EIA standard for category 5e copper cable (TIA/EIA 568-5-A[5]), the maximum length for a cable segment is 100 meters (328 feet). If longer runs are required, the use of active hardware such as a repeater or switch is necessary.[6][7] The specifications for 10BASE-T networking specify a 100 metre length between active devices.[8] This allows for 90 metres of fixed cabling, two connectors and two patch leads of 5 metres, one at each end.
A cable segment refers to a section of a cable that is used to transmit data or signals. It is typically a physical connection between two devices or components.
A repeater is a device used to amplify or regenerate a signal in order to extend the distance that the signal can travel. It receives a weak signal, amplifies it, and then re-transmits it.
The spacing between cable segments is important because it affects the quality and strength of the signal being transmitted. If the spacing is too short, the signal may become distorted or weakened, leading to data errors or loss.
The optimal spacing between cable segments is determined by the type of cable being used, the signal strength, and the distance the signal needs to travel. Other factors such as interference and environmental conditions may also play a role.
The appropriate spacing for cable segments and repeaters can be determined through various methods such as signal strength measurements, simulation software, and industry standards. It is important to consult with experts or refer to technical specifications to ensure proper spacing for optimal signal transmission.