What is the Maximum Range of a Three-Man Water Balloon Launcher?

  • Thread starter Thread starter Phymath
  • Start date Start date
  • Tags Tags
    Balloon Water
AI Thread Summary
The discussion focuses on estimating the maximum range of a three-man water balloon launcher using Hooke's law, specifically the spring constant (k) in relation to the stretch length (x) and mass (m) of the projectile. Participants suggest using energy equations to calculate the velocity of the balloon and verify results through vertical and horizontal launch experiments. It is noted that the latex rubber material of the launcher affects the spring constant, which is not truly constant. A resource is provided for rubber data at various strains to aid in calculations. The conversation emphasizes practical applications for educational purposes, including target practice and trajectory calculations.
Phymath
Messages
183
Reaction score
0
hey what does everyone know/estimate one of those three man giant elastic water balloon launchers has as its k constant in hooke's equation F = -kx

im trying to figure out a max range for one of those for a given strech length x and a given mass m.

i did 1/2 m v^2 = 1/2 k x^2 -> v = sqrt(kx^2/m) then put that all in the projectile formula basic stuff, all this seem sound? or do u think that the mass/projectile will not recive all of the spring energy? idk let me know what u guys think.
 
Physics news on Phys.org
water balloon launcher

I am trying to work out the same thing with the goal of letting my students practice a little water balloon artillery. Try launching the balloon straight up. Calculate the total time of flight. take half the time and multiply that by 9.8 m/s/s that should be the speed at which the balloon hit the ground and the same speed that it left the launcher at. That should match your v from your PE = KE calculation. To veriffy. Launch the balloon horizontally from a given height. Calculate the time it will take for the balloon to fall from that height (d= .5(9.8m/s/s)t^2 gives you t = sqrt(d/2g).
Pull the balloon back the same distance you did on your vertical calculation and let the balloon fly horizontally. Multiply the time you get from calculating the vertical drop by your v from your other calculations and you should get where the balloon lands. If this works you can pulling to other lengths to see if you can get a value for k and then set up targets and work out the angle to hit them. Good luck let me know if this works.
 
These are made of latex rubber, so the "spring constant" isn't a constant.

Here is site with data for up to 300% strain (also used to launch radio control gliders).

http://www.hollyday.com/rich/hd/sailplanes/rubberdata.htm

For the heavy duty tubing, which is 24lbs at 300%, the tension is 27lbs at 350%. You can fill in the rest of the table with this info. I wouldn't go beyond 350%, because then a permanent stretch will result (or the tubing could break).
 
Last edited by a moderator:
I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
Back
Top