Calculating Watt/Watt-Hour for 20W Light Bulb & 8W Wind Turbine

  • Thread starter Thread starter MechaMZ
  • Start date Start date
  • Tags Tags
    Watt
AI Thread Summary
A 20W light bulb running for 2 hours consumes 40Wh of energy, but this does not equate to "40W used in an hour," as watts measure power, not energy. A battery rated at 200W is incorrectly described; it should be rated in watt-hours (Wh) to indicate energy storage, meaning a 200Wh battery could power a 20W bulb for 10 hours. The wind turbine producing 8W for 10 hours generates 80Wh of energy, not watt-hours, as watt-hours depend on the duration of operation. Additionally, while a specific wind turbine can produce 36Wh per day, the battery's capacity should be expressed in amp-hours for accuracy, as a 50Wh battery would only be about 4Ah at 12V. Understanding these distinctions is crucial for accurate energy calculations.
MechaMZ
Messages
127
Reaction score
0
1.
A light bulb which is 20Watt, is run for 2 hours
equals to 40Wh, which mean 40Watt used in an hour

is the concept correct?

2.Assume above was correct.
The 20Watt is powered by a battery which is 200Watt.
This battery can last for 5 hours.

IS the concept above correct?

3.
A wind turbine with 8Watt is connected to the battery(200Watt), to charge the battery before the it connected to the light bulb.
The wind turbine is run for 10 hours, what is the watt-hr of the turbine, and the total wattage in the battery after 10hrs.

thanks
 
Last edited:
Engineering news on Phys.org
MechaMZ said:
1.
A light bulb which is 20Watt, is run for 2 hours
equals to 40Wh, which mean 40Watt used in an hour

is the concept correct?

No, 40 Wh does not mean: 40 Watt used in an hour, that would be 40 W/h. Instead, 40 Wh means: enough energy to give 40 Watt constantly during one hour. Or, 20 W for two hours. Or 1 W for 40 hours. So if you would have a battery of 200 Wh, you could connect a 200 W machine and it would take exactly one hour for the battery to deplete. If you would connect a 50 W device instead, the battery would last for 4 hours.

Remember, that Watt is actually Joules / second, so energy per time. So if e.g. a light bulb is 20 W, that means that it uses 20 J every second. If you leave it on for an hour, it will use (20 J/s) * (3600 s) = 72 kJ.
When using Wh, you are actually multiplying this energy per time by a time again, so you will get an energy. You can even calculate how much a Wh is:
1 Watt * hour = 1 Joule / second * 1 hour = 1 Joule / second * 3600 second = 3600 Joule
So if you get confused, you can just convert from Wh to J, of which you (hopefully) will always know what kind of quantity it is.
 
A Watt-hour is a unit of energy.
A Watt is a unit of power (rate of energy consumption)

So:

1. Not quite. A 20W bulb run for 2 hours will use 40Wh of energy. It's meaningless to say "40W used in an hour", because you're not using up Watts, they're just happening constantly. A vague analogy would be if you're traveling at 20mph for 2 hours, you'd cover 40 miles. But you wouldn't use 40mph in an hour.

2. No, this is not correct. Your battery wouldn't hold 200W, since this is power; not energy. If your battery contained 200Wh of energy, then your 20W bulb would light for 10 hours. (In reality it wouldn't, because your battery would go flat, but you get the idea). An analogy to your premise would be "the car traveling at 20mph has 200mph of fuel in the tank, how long can it drive for?" which is clearly senseless.

3. Since your battery can't be described as 200W, and that batteries don't store power (they store energy), this question is meaningless. A turbine doesn't have a "watt-hour"; a turbine has a power rating (eg 8W). The watt-hour bit depends entirely on how long it's run for, at what power. So, a correct statement would be:

"A wind turbine producing 8W, when run for 10 hours, will produce 80Wh of energy".

Understand?
 
I wouldn't normally pick this up, but it's wrong, and it's relevant, so:

CompuChip said:
No, 40 Wh does not mean: 40 Watt used in an hour, that would be 40 W/h.

No. 40 Watts used over a period of 1 hour would be 40 Watt-hours, not 40 Watts per hour.
 
brewnog said:
A Watt-hour is a unit of energy.
A Watt is a unit of power (rate of energy consumption)

So:

1. Not quite. A 20W bulb run for 2 hours will use 40Wh of energy. It's meaningless to say "40W used in an hour", because you're not using up Watts, they're just happening constantly. A vague analogy would be if you're traveling at 20mph for 2 hours, you'd cover 40 miles. But you wouldn't use 40mph in an hour.

2. No, this is not correct. Your battery wouldn't hold 200W, since this is power; not energy. If your battery contained 200Wh of energy, then your 20W bulb would light for 10 hours. (In reality it wouldn't, because your battery would go flat, but you get the idea). An analogy to your premise would be "the car traveling at 20mph has 200mph of fuel in the tank, how long can it drive for?" which is clearly senseless.

3. Since your battery can't be described as 200W, and that batteries don't store power (they store energy), this question is meaningless. A turbine doesn't have a "watt-hour"; a turbine has a power rating (eg 8W). The watt-hour bit depends entirely on how long it's run for, at what power. So, a correct statement would be:

"A wind turbine producing 8W, when run for 10 hours, will produce 80Wh of energy".

Understand?

thanks for your quick and useful reply.

But for this wind turbine, http://www.reuk.co.uk/Envirotek-V20-VAWT-Generator.htm
It produces 12V, and 3Ah/day under 10mph
It equals to 36Watt-Hour /day under 10mph
So it requires 1.389 Days to fully charge the 50Watt-Hour battery.(Ideally)

Am I correct?
thanks
 
MechaMZ said:
thanks for your quick and useful reply.

But for this wind turbine, http://www.reuk.co.uk/Envirotek-V20-VAWT-Generator.htm
It produces 12V, and 3Ah/day under 10mph
It equals to 36Watt-Hour /day under 10mph
So it requires 1.389 Days to fully charge the 50Watt-Hour battery.(Ideally)

Am I correct?
thanks
All that is correct except (perhaps) the last line. Batteries typically aren't rated in "watt-hours", they are rated in amp-hours. 50 watt-hours for a 12 V battery would only be a little over 4 Ah, which is pretty small for a 12V battery. Typically, people use power tanks for this kind of thing and they run 7-17 Ah: http://www.sears.com/shc/s/p_10153_12605_02871486000P?vName=Automotive
 
Last edited by a moderator:
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Beauty of old electrical and measuring things, etc.'
Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
Back
Top