Please explain me - width of depletion layer varies

AI Thread Summary
The width of the depletion layer in semiconductor junctions varies inversely with doping concentration; lower doping levels result in a wider depletion region due to less charge carrier neutralization. As doping increases, the depletion width decreases because the charge carriers neutralize more quickly over a shorter distance. In reverse bias conditions, increasing the voltage leads to a wider depletion layer, while in a thyristor's forward blocking state, the width of the reverse-biased junction decreases with increased voltage due to local voltage variations. Understanding these dynamics is crucial for semiconductor applications. The interplay of doping levels and voltage conditions significantly influences the behavior of depletion layers.
abhishek91
Messages
1
Reaction score
0
please explain me -- width of depletion layer varies

hey guys,
i need to know how does width of depletion layer varies with various factors and i have mentioned all my queries below
1.first of all i want to know how does width of depletion layer increases with decrease in doping content??as per my knowledge when p and n regions r combined to form a junction electrons from n region and holes from p region move to p and n regions respectively leaving behind immobile charges and from this we can conclude that as the doping content increases width should decrease but opposite of this actually happens.why and how?
2.when we increase the potential drop in case of reverse bias, width of depletion layer increases but in case of thyristor when it is in forward blocking state and we increase the voltage the width of j2 junction which is reversed biased decreases that's what given in md singh and khanchandani. how does all this happen..please someone explain this ...
thanks
 
Engineering news on Phys.org


Semiconductors 101:

http://en.wikipedia.org/wiki/Depletion_region

1. Increasing doping causes neutralization to occur "sooner" in distance ergo smaller width, and vice versa.

2. The voltage is relative to other junctions - locally it is less reverse biased.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »
Thread 'Beauty of old electrical and measuring things, etc.'

Thread 'Beauty of old electrical and measuring things, etc.'

Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
View full post »

Similar threads

Effect of Doping on Depletion Region Width
Replies
8
Views
16K
What Explains the Lack of Current in a PN Junction at Equilibrium?
Replies
3
Views
2K
Doubt on Depletion Layer Width in Biased pn-Jnction
Replies
1
Views
3K
Calculating the speed of a JFET
Replies
1
Views
1K
Effect of doping level on the width of the depletion layer
Replies
4
Views
3K
Depletion width of linearly doped PN-junction
Replies
1
Views
1K
Diffusion current and carrier concentration equilibrium (unbiased)
Replies
1
Views
1K
Understanding the width of the depletion region in a p-n junction
Replies
6
Views
16K
B What is the purpose of the depletion region in P-N junction semiconductors?
Replies
2
Views
3K
B Forward Bias: Why does width of depletion layer decrease?
Replies
1
Views
10K

Hot Threads

Recent Insights

Back
Top