Capacitor Cooling: Circuit Info & Bench Cooling

  • Thread starter Thread starter raburgeson
  • Start date Start date
  • Tags Tags
    Cooling
AI Thread Summary
Capacitor cooling is expected to enhance the stability and lifespan of computers by reducing heat generation. The discussion seeks information on the specific circuits involved in capacitor cooling and practical methods for cooling capacitors on a workbench. Participants express a lack of reference materials and technical details available online. A link to a relevant academic source is provided, but further insights are requested. Understanding the cooling techniques for capacitors is crucial for improving electronic performance.
raburgeson
Messages
3
Reaction score
0
I just read computers are going to run cooler because of capacitor cooling.
What type of circuit is involved and how could I cool a small cap on the bench.
 
Engineering news on Phys.org
Try posting some sort of reference.
 
That's the problem,read this on tech news straight from the news link off yahoo's front
page. Being it is a piece on computers and not circuits, it only stated that this cooling
will add extra stabability and product life,it did not cover techniq.I have no reference
material nor can find anything on the net so I came here for help on getting information
on this subject.
 

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Possible to change a thermistor resistance curve?
Replies
19
Views
5K
How do I properly connect a bench power supply to a pulse generator for testing?
Replies
19
Views
2K
Basic question about RLC circuits
Replies
32
Views
2K
How Does a Capacitor Introduce Phase Delay in a Circuit?
Replies
9
Views
2K
Building a Safe and Efficient Induction Heater Circuit: Tips and Tricks
Replies
7
Views
6K
Question about the Redistribution of Charges
Replies
4
Views
2K
Capacitor charge time, two conflicting answers
Replies
6
Views
229
Can Power Be Measured as V^2/R Using a Bench Meter?
Replies
21
Views
2K
Samsung double door fridge overload relay changed 3 times in 2 weeks
Replies
12
Views
4K
Is My Thyristor Gate Driver Circuit Malfunctioning Due to Component Issues?
Replies
12
Views
2K

Hot Threads

Recent Insights

Back
Top