Is that star load will make unbalance load, delta will not?

  • Thread starter Thread starter tom1300
  • Start date Start date
  • Tags Tags
    Delta Load Star
AI Thread Summary
Star loads can potentially be unbalanced, while Delta loads are generally associated with higher power applications and are typically more balanced. The distinction between Star and Delta configurations does not inherently determine load balance. Star loads are often single-phase and lower power, whereas Delta loads are usually three-phase and dedicated to specific applications. Ultimately, the balance of a load depends on the specific characteristics of the connected devices rather than the configuration alone.
tom1300
Messages
1
Reaction score
0
is that star load will make unbalanced , delta will not?

THX
 
Engineering news on Phys.org
I really do not know for sure what you are asking - Are you asking if Star Loads may be imbalanced but delta loads are not - or Delta by nature are always balanced?

The Star and Delta loads have nothing to do with being balanced.

Typically Star loads are single phase loads, and lower power. Delta loads, are usually dedicated to something specific (like three phase motors), and higher power.

But none of this is set in stone.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Following up on the recent thread about Earth Resistance measurements'

I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
View full post »
Thread 'Beauty of old electrical and measuring things, etc.'

Thread 'Beauty of old electrical and measuring things, etc.'

Even as a kid, I saw beauty in old devices. That made me want to understand how they worked. I had lots of old things that I keep and now reviving. Old things need to work to see the beauty. Here's what I've done so far. Two views of the gadgets shelves and my small work space: Here's a close up look at the meters, gauges and other measuring things: This is what I think of as surface-mount electrical components and wiring. The components are very old and shows how...
View full post »

Similar threads

How electricity distributers achieve equal phase loads?
Replies
5
Views
1K
Generator load sharing
Replies
4
Views
2K
Star, delta, and star&delta motors
Replies
1
Views
1K
How to make an Electrical Diagram with added Steinmetz Circuit for a Delta 3 phase motor?
Replies
0
Views
1K
Power managment for this circuit supplying power to my pump load
Replies
21
Views
2K
Calculating phase currents from line currents in an unbalanced delta
Replies
35
Views
5K
What Should Be the Overload Relay Values in a Star-Delta Diagram?
Replies
7
Views
8K
Understanding Delta & Star Load Connections
Replies
4
Views
2K
Lithium Charging Load Resistance?
Replies
10
Views
2K
Transformer load reading calculation
Replies
4
Views
3K

Hot Threads

Recent Insights

Back
Top