Ultracapacitor to power electromagnet?

AI Thread Summary
Using ultracapacitors to power an electromagnet offers advantages over AA batteries, such as higher discharge rates, but they have lower energy density and provide only short bursts of power. The discussion highlights a specific ultracapacitor option with a 60mΩ ESR, suggesting a maximum current of 45A, but the actual current draw will depend on the resistance of the electromagnet. Connecting capacitors in series increases voltage but decreases total capacitance and may also raise resistance, which could limit performance. Charging ultracapacitors can be done using batteries or a step-down transformer from mains power, but safety precautions are essential due to potential hazards. Overall, while ultracapacitors can be beneficial for short-term power needs, users should consider the limitations and safety concerns associated with their use.
Pharrahnox
Messages
106
Reaction score
0
I have been looking for a better way to power my electromagnet than a bunch of AA batteries, and am now thinking of using ultracapacitors.

I have a few questions.

I have been looking on ebay for them, I don't know of better options, and I have seen mostly 2.7V with >1F, up to 1500F. One in particular has grabbed my attention 10X 2.7V 10F ultracapacitors, for < $25, and they are stated to have: ESR (mΩ, 1KHz, 25℃) : 60

Does that mean that it has 60mΩ of resistance, therefore a maximum current of 2.7/0.06 = 45A?

What are the pros and cons of using capacitors as the power source for an electromagnet?

I think the resistance of my magnet is about 6-7Ω, so 2.7/6.5+0.06 = 0.41A. So I don't think the current would be too much, and I can always add more turns of wire (I have about 2500).

How could I connect the capacitors so that I can get more amperage? I know that connecting them in series adds their voltages, and decreases capacitance, but would that then also increase the resistance, rendering it useless?

Also, since the capacitors are rated at 2.7V, how do I charge them? I don't know of any 2.7V power sources... Also, is it possible to safely charge them off mains power, using a step down transformer?

Are there many dangers of what I am trying to do with these capacitors? If so, I would like to know, so I can prevent any injury or damage to myself or to the electrical circuits involved.

Thanks for any responses. Sorry about all the questions.
 
Physics news on Phys.org
You're probably best off sticking with batteries. Ultracapacitors still have much lower energy density than batteries, and you'll only get a couple seconds of use (or less) out of them before they die.
 
Pharrahnox said:
Also, since the capacitors are rated at 2.7V, how do I charge them? I don't know of any 2.7V power sources... Also, is it possible to safely charge them off mains power, using a step down transformer?
You could use batteries to charge them.

Where is the problem with AA batteries? If you need more short-term power, a capacitor in parallel to batteries could be interesting.
 
Perhaps use SubC, C or D size NiMh rechargable batteries? They will have greater capacity and higher current capability. Should be able to find chargers easily.

I hesitate to recommend Lithium rechargable for safety reasons. It's just too easy to burn your house down.
 
I was using the Smith chart to determine the input impedance of a transmission line that has a reflection from the load. One can do this if one knows the characteristic impedance Zo, the degree of mismatch of the load ZL and the length of the transmission line in wavelengths. However, my question is: Consider the input impedance of a wave which appears back at the source after reflection from the load and has traveled for some fraction of a wavelength. The impedance of this wave as it...
Back
Top