Calculating temperature change

AI Thread Summary
The discussion focuses on the efficiency of air preheaters in industrial boilers, noting that a 40°F increase in combustion air temperature can save approximately 1% of fuel. A participant seeks to convert this temperature increase to Celsius, using the formula Tc = 5*(Tf-32)/9. The calculation confirms that a 40°F rise corresponds to about 22.2°C. It is clarified that for delta-T calculations, the specific temperature scales are not necessary, simplifying the conversion to a ratio. The conversation concludes with a confirmation of the calculation's accuracy.
Micko
Messages
43
Reaction score
0
Hello to all,

I'm reading one article about boiler. I have found one interesting fact about air preheater used in industrial boiler. It goes something like this "Approximately 1% of fuel is saved for each 40 F rise in combustion air temperature.

Now, since I'm in Europe, I want to know how much this is in deg Celsius.
Just want confirmation about this:
since Tc = 5*(Tf-32)/9, this will be Tc2 = 5*(Tf1+40-32)/9.
This will lead to: Tc2-Tc1 = 40/9 +160/9 = 200/9 = 22.2 C
Is this correct?
 
Science news on Phys.org
Yes, though since you are just doing delta-T's, you don't need to attach them to their respective scales to do the math. Just multiply or divide by the ratio: 40/1.8=22.2
 
OK, thanks
 
I need to calculate the amount of water condensed from a DX cooling coil per hour given the size of the expansion coil (the total condensing surface area), the incoming air temperature, the amount of air flow from the fan, the BTU capacity of the compressor and the incoming air humidity. There are lots of condenser calculators around but they all need the air flow and incoming and outgoing humidity and then give a total volume of condensed water but I need more than that. The size of the...
Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'
Let's say we have a cylinder of volume V1 with a frictionless movable piston and some gas trapped inside with pressure P1 and temperature T1. On top of the piston lay some small pebbles that add weight and essentially create the pressure P1. Also the system is inside a reservoir of water that keeps its temperature constant at T1. The system is in equilibrium at V1, P1, T1. Now let's say i put another very small pebble on top of the piston (0,00001kg) and after some seconds the system...
Back
Top