Can anyone provide data on the CY20F high voltage diode?

AI Thread Summary
The discussion centers on the search for a datasheet for the CY20F high voltage diode, specifically a 20 kV component. The original poster has been unable to find relevant data and is seeking assistance. Two companies known for high voltage diodes, CKE and OCRAM, are mentioned as potential sources. The conversation highlights the difficulty in locating specific technical information for this diode. Overall, the thread emphasizes the need for more accessible data on high voltage diodes.
Ravaner
Messages
134
Reaction score
3
Hello. I search, unsuccesfully, the datasheet for this component which is 20 kV diode. If someone has any data about it ...
 
Engineering news on Phys.org
I do not know of this diode - and can not find a DS 0 two companies I know of doing HV Diodes are CKE ( http://www.deantechnology.com/pg_home/home.aspx ) and OCRAM in Italy (http://www.ocramitaly.it/en/high-voltage-rectifiers-up-to-180-kv.html ) -

I am sure there are others - these are just the two I know of off the top of my head.
 
Last edited by a moderator:
Thanks for reply
 

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »

Thread 'Question about the voltage between two charged capacitors'

suppose you have two capacitors with a 0.1 Farad value and 12 VDC rating. label these as A and B. label the terminals of each as 1 and 2. you also have a voltmeter with a 40 volt linear range for DC. you also have a 9 volt DC power supply fed by mains. you charge each capacitor to 9 volts with terminal 1 being - (negative) and terminal 2 being + (positive). you connect the voltmeter to terminal A2 and to terminal B1. does it read any voltage? can - of one capacitor discharge + of the...
View full post »
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Similar threads

Can RF101 Diodes Be Used in Low-Frequency Recovery Circuits?
Replies
7
Views
1K
Creating a negative voltage rail for MOSFET driver
Replies
5
Views
2K
Pwrng a 1064nm Diode/Laser Pointer w/Voltage Regulation
Replies
32
Views
3K
Need help with PIN diode selection in RF switching circuit
Replies
2
Views
1K
Trouble building a Buck Converter
Replies
14
Views
2K
Bidirectional current switching with single type transistor
Replies
42
Views
4K
Building a Buck Converter Using the LT1170
Replies
10
Views
2K
How Does the Micsig DP2003 Handle High Voltage Measurements?
Replies
5
Views
1K
Variable vs constant power supply
Replies
32
Views
2K
How does a voltage regulator differ from a zener diode?
Replies
38
Views
4K

Hot Threads

Recent Insights

Back
Top