Contain radioactive fallout in soil

  • Thread starter Thread starter rosec168
  • Start date Start date
  • Tags Tags
    Radioactive Soil
AI Thread Summary
Neutralizing radioactivity in soil using paramagnetic clays or ashes is proposed as a method to chelate and bind radioactive particles, preventing plant absorption. However, there are doubts about the effectiveness of this method for all types of radioactive particles. Questions arise regarding the quantity of clay and ash needed for treatment on a large scale, such as an acre of soil. The discussion also highlights a lack of documented experiments or articles confirming the efficacy of this approach. Overall, while the concept is intriguing, its practical application and verification remain uncertain.
rosec168
Messages
2
Reaction score
0
I read about neutralizing radioactivity in soil by using paramagnetic clays or ashes because it may chelate the radioactive particles and bind them tightly so they cannot be absorbed by the plant.

How true is that?
 
Engineering news on Phys.org
I'm not sure, but I have doubts that ALL types of radioactive particles can be neutralized by this method. Plus, how much clay and ash do you need to use on, say, an acre of soil? Do we have enough?
 
Drakkith said:
I'm not sure, but I have doubts that ALL types of radioactive particles can be neutralized by this method. Plus, how much clay and ash do you need to use on, say, an acre of soil? Do we have enough?

Yes, we have many tons. But is there any article about radioactive particles that can be chelated by this method? Is there a lab or has somebody conduct any experiment that can prove this?
 
rosec168 said:
Yes, we have many tons. But is there any article about radioactive particles that can be chelated by this method? Is there a lab or has somebody conduct any experiment that can prove this?

No idea, sorry. Interesting if it's true though.
 
Hello everyone, I am currently working on a burnup calculation for a fuel assembly with repeated geometric structures using MCNP6. I have defined two materials (Material 1 and Material 2) which are actually the same material but located in different positions. However, after running the calculation with the BURN card, I am encountering an issue where all burnup information(power fraction(Initial input is 1,but output file is 0), burnup, mass, etc.) for Material 2 is zero, while Material 1...

Similar threads

Back
Top