Does Voltage or Wattage Affect Electric Heater Efficiency?

  • Thread starter Thread starter sheperd
  • Start date Start date
AI Thread Summary
The discussion centers on the efficiency of 110V versus 220V electric heaters. A 220V heater is generally more efficient as it reduces power loss in the wiring, leading to lower electrical bills. Wattage remains constant regardless of voltage, but a 220V system draws less current, resulting in less heat generated in the wiring. The conversation also touches on the challenges of using a 110V 50Hz air conditioner in a 220V 60Hz system, indicating that additional equipment may be needed for compatibility. Overall, for heating efficiency, a 220V system is preferred.
sheperd
Messages
4
Reaction score
0
Hi Friends,

Is anybody please tell me which heater is more efficient (which one I have to choose in order to reduce my electrical bill) 220V electric heater or 110V electric heater for the house or if I choose 1500W heater in 110V or 220V is that make any difference

Thank you

Sheperd
 
Engineering news on Phys.org
Ideally there would be no difference (same power, same bill), however the 220V heater will waste less power in heating your house wires. So, 220v is better.
 
The last answer omits the fact that most of your house wiring would also be heating the house. You would gain more by considering how heat is lossed.
Ray.
 
Just so you know why, wattage is the product of volts times amperes. So a 1500 watt load designed for 110 volts will draw 13.64 amps, at 220 pulls 6.82 amps. As mentioned, the only difference is slightly more or less heating of the house wiring.
 
What do I need in order to use 110V 50Hz air condition to a place which has 220v 60Hz

What do I need in order to use 110V 50Hz air condition to a place which has 220v 60Hz electrical system?
Is that possible?
If yes How?

Please help me

Thank you

Sheperd
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top