Does Water Reduce the Impact and Heat of Collisions Compared to Air?

AI Thread Summary
Collisions in water may have a different impact compared to those in air due to water's density and ability to absorb energy. The surrounding water can dissipate some of the collision's force more effectively than air, potentially reducing the overall impact. Additionally, the heat generated from friction during a collision is likely to be cooled more rapidly in water than in air, due to water's higher thermal conductivity. This suggests that water may mitigate both the impact force and heat generation in collisions. Overall, the medium of collision plays a significant role in the dynamics of impact and heat dissipation.
v_pino
Messages
156
Reaction score
0
Does a collision that happens in water have a stronger impact than a collision on land?
 
Physics news on Phys.org
Only if it collides harder.
 
i would imagine that the surrounding water would absorb some of the impact more than air particles,
and also wouldn't the heat caused by the friction be cooled more quickly by water
 
Hello everyone, Consider the problem in which a car is told to travel at 30 km/h for L kilometers and then at 60 km/h for another L kilometers. Next, you are asked to determine the average speed. My question is: although we know that the average speed in this case is the harmonic mean of the two speeds, is it also possible to state that the average speed over this 2L-kilometer stretch can be obtained as a weighted average of the two speeds? Best regards, DaTario
The rope is tied into the person (the load of 200 pounds) and the rope goes up from the person to a fixed pulley and back down to his hands. He hauls the rope to suspend himself in the air. What is the mechanical advantage of the system? The person will indeed only have to lift half of his body weight (roughly 100 pounds) because he now lessened the load by that same amount. This APPEARS to be a 2:1 because he can hold himself with half the force, but my question is: is that mechanical...
Thread 'Beam on an inclined plane'
Hello! I have a question regarding a beam on an inclined plane. I was considering a beam resting on two supports attached to an inclined plane. I was almost sure that the lower support must be more loaded. My imagination about this problem is shown in the picture below. Here is how I wrote the condition of equilibrium forces: $$ \begin{cases} F_{g\parallel}=F_{t1}+F_{t2}, \\ F_{g\perp}=F_{r1}+F_{r2} \end{cases}. $$ On the other hand...
Back
Top