Ee student in university of michigan

AI Thread Summary
An individual is seeking advice from current electrical engineering students at the University of Michigan, expressing feelings of being lost as they prepare to start their studies after completing some coursework in Lebanon. They are considering whether to begin their undergraduate program anew at age 21. The discussion includes a reminder that the typical duration for a Bachelor of Science in Electrical Engineering (BSEE) is four years, with an additional year for a Master of Science in Electrical Engineering (MSEE). The original poster is looking for guidance on navigating the program and understanding any changes that may have occurred since the 1980s. Overall, they are eager to connect with students for support and information.
moe_3_moe
Messages
72
Reaction score
0
hey can i talk with any ee student of university of michigan...:rolleyes:
 
Engineering news on Phys.org
I got my MSEE there in 1980. Does that count? Or do you need a current UofM EE student?
 
ah good ... i am going to michigan in 4 days and i am absolutely lost about what to do i studied my lower division here in lebanon and 1 semester in the upper division...they can count them but i am thinking to begin again ... i am 21 now i hope it is not a problem ...what do u think?
 
and i wanted to ask about the time it takes me to finish the undergraduate program...but i think it is new now ... u are an old student there...
 
Sorry it took me a while to get back to your thread. Normally the BSEE takes four years, and the MSEE takes an additional year. I doubt that has changed at UofM over the years. Best of luck!
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Replies
15
Views
2K
Replies
7
Views
294
Replies
4
Views
1K
Replies
7
Views
2K
Replies
12
Views
3K
Replies
18
Views
2K
Back
Top