Equation for Sinusoidal Function for Mass Above Table Top

AI Thread Summary
The discussion focuses on deriving the sinusoidal function for a mass undergoing simple harmonic motion, supported by a spring and initially positioned 0.5 m above a table. The mass is pulled down 0.4 m and released, leading to periodic motion with a period of 1.2 seconds. The amplitude of the motion is determined by the distance pulled down, and the angular frequency is calculated as ω = 2π/1.2 seconds. The general form of the sinusoidal function is expressed as y = A cos(ωt) + h, where h accounts for the height above the table. The conversation emphasizes the relationship between cosine and sine functions, noting that both can represent the motion with appropriate phase shifts.
lomantak
Messages
10
Reaction score
0
A mass is supported by a spring so that it rests 0.5 m above a table top. The mass is pulled down 0.4 m and released at time t=0. This creates a periodic up-and-down motion, called simple harmonic motion. It takes 1.2 s for the mass to return to the low position each time.

Could someone please give me an equation of the sinusoidal function when the height of the mass above the table top is a function of time for the first 2.0 s?

Thanks.
 
Physics news on Phys.org
You know the amplitude and you know the frequency (via the period). What more do you need? :)
 
Your amplitude is given to you (the amount pulled down). The period, 1.2s, is the amount of time it will take to go all the way up, and then back down again.

Remember your unit circle? In this case, the low point corresponds to \cos{\pi}. It makes one full revolution around the unit circle in 1.2 seconds. Since the entire circle (2\pi) is traveled once, then \omega = \frac{2\pi}{1.2sec} where \omega is called the angular frequency. Basically, \omega is the angular rate of change in t seconds.

So, if cosine is at a maximum of 1 and a minimum of -1, then you need to multiply it by the amplitude at its maximum and minimum to get the max and min amplitudes, right?

y = A\cos{(\omega t)}
But, it's 0.5m above the table, so everything is shifted up h = 0.5m
y = A\cos{(\omega t)} + h

I'll leave you to do the actual calculations, but hopefully you see how this works. Also note that cosine and sine are the same function, but cosine is shifted by pi/2 radians. You could also write that as y = Asin( wt + pi/2 ) + h
 
Last edited:
Back
Top