GCC XL20/600 Printer: Upgrading Resolution to 800/1200

  • Thread starter Thread starter ricardo_s
  • Start date Start date
  • Tags Tags
    Board Gcc
AI Thread Summary
The discussion focuses on upgrading the GCC XL20 printer's resolution from 600 to 800 or 1200 DPI. The user seeks a technical diagram and firmware to backup and flash the printer's ROM, specifically the Intel E28F800B5B70. They note that while the engines are the same across models, the available manual does not provide the necessary configuration details for achieving higher resolution. The conversation highlights the challenge of finding specific technical resources for this upgrade. Overall, users express frustration over the lack of accessible information for modifying the printer's capabilities.
ricardo_s
Messages
2
Reaction score
0
Hello guys,
I am trying to find a technical diagram for a GCC XL20 printer. I am trying to get the 600 resolution to go up to 800 or 1200. They all use the same engines but I can't find the firmware or the utility to backup and flash the rom. they are flashabe. The roms are intel E28F800B5B70, any ideas how to get pass the buckle neck on the printer?
 
Engineering news on Phys.org
http://www.retrevo.com/s/GCC-XL-20%2F1200-Printers-review-manual/id/23011dj086/t/1-2/
Looks like you could get the manual there.

Your query is already on Google.
 
Last edited by a moderator:
The manual doesn't give any configuration at board level, and it doesn't show how to get the resolution any higher.


It's not a technical manual.
 

Thread '3-terminal device external modeling'

Very basic question. Consider a 3-terminal device with terminals say A,B,C. Kirchhoff Current Law (KCL) and Kirchhoff Voltage Law (KVL) establish two relationships between the 3 currents entering the terminals and the 3 terminal's voltage pairs respectively. So we have 2 equations in 6 unknowns. To proceed further we need two more (independent) equations in order to solve the circuit the 3-terminal device is connected to (basically one treats such a device as an unbalanced two-port...
View full post »
Thread 'Weird near-field phenomenon I get in my EM simulation'

Thread 'Weird near-field phenomenon I get in my EM simulation'

I recently made a basic simulation of wire antennas and I am not sure if the near field in my simulation is modeled correctly. One of the things that worry me is the fact that sometimes I see in my simulation "movements" in the near field that seems to be faster than the speed of wave propagation I defined (the speed of light in the simulation). Specifically I see "nodes" of low amplitude in the E field that are quickly "emitted" from the antenna and then slow down as they approach the far...
View full post »

Similar threads

Requesting suggestions for languages, libraries, and architectures for parallel (and sometimes non parallel) numerical and scientific computations
Replies
8
Views
4K
Exhaust and engine accoustics for asthetics and performance
Replies
2
Views
7K
Mathematica This Week's Finds in Mathematical Physics (Week 236)
Replies
7
Views
3K
Mathematica This Week's Finds in Mathematical Physics (Week 236)
Replies
9
Views
3K

Hot Threads

Recent Insights

Back
Top