Ground question and pen voltage detectors.

AI Thread Summary
Touching a hot wire while standing on a carpeted floor with rubber-soled shoes typically does not result in a shock due to insulation, although small currents can still pass through. Pen voltage detectors operate using inductive pickup coils, allowing them to detect voltage without direct contact. Older models may use neon bulbs that require minimal current to illuminate, which can lead to small leakage currents through the user’s body. The concept of grounding is discussed, emphasizing that being 'grounded' implies a direct connection to the ground through a conductor, while resistance affects current flow. Understanding these principles is crucial for safe electrical practices.
djdoug99
Messages
15
Reaction score
0
Hi, I am new here and have a couple questions.

First, If someone is standing in their house on a carpeted floor with rubber soled shoes on and they only touch the hot wire, will they get a shock?

Also, can anyone explain how those pen voltage detectors work where you only have to touch one wire to see if its hot or not.

Thanks
 
Engineering news on Phys.org
djdoug99 said:
First, If someone is standing in their house on a carpeted floor with rubber soled shoes on and they only touch the hot wire, will they get a shock?

It depends on the circumstances, but generally no, you will not get shocked if you are well insulated. Small current can still pass through you.


Also, can anyone explain how those pen voltage detectors work where you only have to touch one wire to see if its hot or not.

Most pen detector have inductive pick up coils so you don't even have to touch a wire. Some of the older ones use small neon bulbs. They require little current to glow, so when you touch a hot wire with one end of the neon bulb, some small leakage current will flow and find a path of least resistance to the ground, usually through your body.
 
So then isn't everything technically grounded. It just depends on the amount of resistance that determines the amount of current delivered. Or does being 'grounded' suggest that the subject is directly connected to ground through a conductor?
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
Thread 'Electromagnet magnetic field issue'
Hi Guys We are a bunch a mechanical engineers trying to build a simple electromagnet. Our design is based on a very similar magnet. However, our version is about 10 times less magnetic and we are wondering why. Our coil has exactly same length, same number of layers and turns. What is possibly wrong? PIN and bracket are made of iron and are in electrical contact, exactly like the reference design. Any help will be appreciated. Thanks. edit: even same wire diameter and coil was wounded by a...
Back
Top