How to use 4-bit parallel adders to perform 2Cs' subtraction?

  • Thread starter Thread starter chipmunk22
  • Start date Start date
  • Tags Tags
    Parallel
chipmunk22
Messages
15
Reaction score
0
Does anyone know how to use 4-bit parallel adders to perform 2Cs' subtraction? Thanks.
 
Last edited:
Engineering news on Phys.org
Just complement one input with inverters and add it to the other input.
 
oh i see. Thks!
 

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Similar threads

Designing a 2-bit full adder using nothing but NAND gates?
Replies
15
Views
9K
8-Bit Ripple Carry Multiplier using 4-Bit Adders
Replies
6
Views
7K
Ripple-Carry Adder for 2s complement
Replies
1
Views
2K
Comp Sci Digital Logic 8 Bit Full Adder Circuit
Replies
5
Views
3K
MHB Optimizing Carry-Skip Adders for Minimal Delay
Replies
3
Views
1K
Full Adder modified to make Full Subtractor
Replies
2
Views
27K
How many Parallel Resistive Loads I connect in a 110V branch?
Replies
14
Views
1K
Where to find sources on Full Adders
Replies
1
Views
2K
Engineering Selecting operation code for arithmetic circuit that uses the least amount of transistors and other inquiry
Replies
4
Views
1K
Make half and full adder without chips
Replies
15
Views
4K

Hot Threads

Recent Insights

Back
Top