I found this wouldn't stop spin

  • Thread starter Thread starter sleepsleep
  • Start date Start date
  • Tags Tags
    Spin
AI Thread Summary
The discussion reveals that lowering and raising a spinning object by 2 or 3 mm increases its spin rather than stopping it. An illustrated diagram is provided to support the findings. The PNG file format is mentioned, highlighting its compatibility with various web browsers. The conversation emphasizes the unexpected results of the test conducted. Overall, the experiment challenges assumptions about stopping spin dynamics.
sleepsleep
Messages
21
Reaction score
0
i tried the following test, and found it wouldn't stop spin and in fact would spin more faster if u low it 2 or 3 mm and raise it up 2 or 3 mm during it spins.

the "illustrated diagram" (the best i could draw using paint shop pro) :p
http://www.boinc.ch/~sleepsleep/energy.png
 
Last edited by a moderator:
Engineering news on Phys.org
What kind of file is a PNG extension?
 
png is portable network graphics ( http://en.wikipedia.org/wiki/PNG ) , it could be viewed with IE browser, or firefox or opera or etc
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Thread 'What happens if shielded cable has short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Similar threads

I Spin and wavefunction of excitons
Replies
2
Views
2K
I A scientific analysis of stopping the spin of Discovery One spaceship
Replies
3
Views
2K
Troubleshooting Strange Noise from 250kw 3 Phase Motor
Replies
4
Views
5K
Photo Contest - Spin Angular Momentum (6/23-6/29)
Replies
22
Views
2K
B Experiment issues (electromagnetism)
Replies
42
Views
2K
How can I make my spinning ring last longer?
Replies
6
Views
2K
I Understanding Relativistically Spinning Disk/Ring: Lorentz Boosts
Replies
13
Views
2K
I Non-locality by memory (Jung, 2020) applied to stochastic mechanics
Replies
5
Views
1K
Building a Safe and Efficient Induction Heater Circuit: Tips and Tricks
Replies
7
Views
6K
Why is it so much easier to lift a spinning gyro than if stationary?
2
Replies
67
Views
23K

Hot Threads

Recent Insights

Back
Top