Is Majoring in Biomedical Engineering the Best Path for a Career in the Field?

  • Thread starter Thread starter unggio
  • Start date Start date
  • Tags Tags
    Opinions
AI Thread Summary
Majoring in biomedical engineering is recommended for those aiming for a career in the field, especially if graduate school is a goal. A physics major may enhance problem-solving skills but could detract from familiarity with biomedical engineering concepts. Minoring in physics while majoring in biomedical engineering is suggested as a balanced approach. Concerns about the physics GRE and its memorization requirements are noted, indicating potential challenges. Ultimately, a focus on biomedical engineering is advised for better preparation and success in the field.
unggio
Messages
23
Reaction score
0
im thinking about getting a bachelors in physics and a minor in biomedical engineering at UC Irvine.

i want to end up in biomedical engineering as a career.

physics will give me better problem solving skills than engineering, and hopefully will not kill my GPA. i also like physics.

good idea?

i also plan on eventually attending graduate school in BME.

(the physics GRE scares me, you have to memorize all the equations)
 
Engineering news on Phys.org
Bad idea.

They both solve problems. In you want to end up in biomedical engineering,
get into [drum roll please] biomedical engineering for your major.
 
I would also agree that if you plan to go to grad school for biomedical engineering, you should major in it as well. It will make you more familiar with the field that you are going into. If you still want to do physics, perhaps minoring in that?
 
Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
Back
Top