Need a mecanical generator for experimentation.

  • Thread starter Thread starter mzr99
  • Start date Start date
  • Tags Tags
    Generator
AI Thread Summary
A manual generator that is small yet modular is sought for experimentation, ideally at a low cost. Stepper motors are recommended for their ability to generate electricity at lower RPMs, making them suitable for hand cranking. They produce AC voltage, requiring additional components like diodes for conversion to usable DC. Small DC permanent magnet motors are also suggested as affordable alternatives, easily sourced from old toys. These options provide a practical foundation for conducting preliminary experiments with mechanical energy generation.
mzr99
I need a manual generator.

(i.e.: A gadget that generates electricity by using some mechanical energy).

It has to be small - but not miniature.

Also, I need it (if possible) modular, so one can attach other devices to it (to provide it with the mechanical energy)

I would like it not to be too expensive.

I would appreciate any pointers.

Thanks in advance.
[al]
 
Engineering news on Phys.org
Thank you.
 
hmm I've just browsed about "Piezo Motor" really tiny about 1mm x 1mm x 6mm
 
A really handy generator is a stepper motor. Common DC motors require a fairly high RPM to produce a reasonable voltage, but a stepper motor with a handle will get you there with reasonably slow hand cranking.

Stepper motors are all over the surplus market for as little as a few dollars. I fabbed up a crank for stepper which drove small incandescent lamps for a kid's science fair project. Worked great.

Just remember, it puts out AC voltage, so it will need diodes and maybe some capacitors to get it into a usable DC voltage.

- Mike
 
The stepper motor is a good idea but a small DC permanent magnet motor is a simple machine to do some preliminary experiments. You can get them out of old toys or stuff around the house, or buy them pretty cheap too. You can turn it with a variable speed drill and note the voltage increase at higher rpm, and do measurments with an rpm sensor and voltmeter.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
Back
Top