New type of electric motor (true BLDC)

AI Thread Summary
The discussion centers on a proposed new type of electric motor, described as a true BLDC, which has not yet been prototyped. Concerns are raised about its low power density and efficiency, indicating it is unlikely to replace existing brushed or brushless motors. The creator seeks feedback and insights on why this motor design has not been previously developed. Participants are encouraged to share their opinions and criticisms regarding the feasibility of the concept. The conversation emphasizes the need for a physical prototype to validate the motor's performance claims.
ZenonDorin
Messages
11
Reaction score
0
K-yyJF-kTMw[/youtube]I'm not 100% s...is before, or why do you think it can't work?
 
Last edited:
Engineering news on Phys.org
Give more details about the motor that has not anyone invented yet.
 
Sorry, forgot to embed the video..
 
ZenonDorin said:
K-yyJF-kTMw[/youtube] I'm not ... Did you make the prototype of your idea?
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

Antique electric railway maintenance equipment
Replies
1
Views
418
How are BLAC motors wound and what makes them different from BLDC motors?
Replies
1
Views
8K
Power-to-weight ratio of electric motors
Replies
2
Views
9K
Is the coil the only viable shape for an electric engine ?
Replies
2
Views
1K
Remarkable New Marine Propulsion Systems
Replies
5
Views
4K
How important is it to keep an air motor warm?
Replies
11
Views
2K
Automotive Help on throttle mapping for gas/electric hybrid motor
Replies
24
Views
3K
Lorentz force in motor other than homopolar
Replies
1
Views
2K
New Electric Motor: How to Hook Up & Test Power Supply
Replies
8
Views
5K
Advice and opinions on hydraulic drive buggy
Replies
2
Views
4K

Hot Threads

Recent Insights

Back
Top