Newbie Spammer Banned from ME Forum

  • Thread starter Thread starter berkeman
  • Start date Start date
  • Tags Tags
    Forum
AI Thread Summary
A user named @mechanicalengineer posted a vague question about running five DC motors at the same RPM without feedback in the ME forum. Despite attempts from other users to provide assistance, it was discovered that he was a spammer promoting his website in other posts. As a result, he has been banned from the forum, and all his posts and threads have been removed. His information has also been added to a shared spammer database used by the forum. The thread's disappearance is attributed to this spam activity.
berkeman
Admin
Messages
69,099
Reaction score
23,981
Hi Folks,

Newbie @mechanicalengineer had posted a thread (I think it was in the ME forum) where he asked a vague question about how to run 5 DC motors at the same RPM without using feedback. A number of users tried to post helpful replies, despite the OP's thread start being so vague.

Turns out @mechanicalengineer was a spammer, posting a link to his website in other posts after this one. He is now banned as a spammer, which cleans up all of his posts and threads, and adds him to the shared spammer database that the PF subscribes to.

I just wanted to let you all know why the thread has disappeared. Thanks for trying to help the newbie -- too bad it was a spam setup.
 
Last edited:
  • Like
Likes CalcNerd, Bystander and phinds
Engineering news on Phys.org
Posted June 2024 - 15 years after starting this class. I have learned a whole lot. To get to the short course on making your stock car, late model, hobby stock E-mod handle, look at the index below. Read all posts on Roll Center, Jacking effect and Why does car drive straight to the wall when I gas it? Also read You really have two race cars. This will cover 90% of problems you have. Simply put, the car pushes going in and is loose coming out. You do not have enuff downforce on the right...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Thread 'What's the most likely cause for this carbon seal crack?'
We have a molded carbon graphite seal that is used in an inline axial piston, variable displacement hydraulic pump. One of our customers reported that, when using the “A” parts in the past, they only needed to replace them due to normal wear. However, after switching to our parts, the replacement cycle seems to be much shorter due to “broken” or “cracked” failures. This issue was identified after hydraulic fluid leakage was observed. According to their records, the same problem has occurred...

Similar threads

Back
Top