I think I got the answer by looking at what I got from the binomial formula.
- I recommend you start from the left side first (x-2)3
- I tend to agree with Sahil Kukreja's advice. He or she provided a good tip. ( I think ) .
- I think I got the basic idea, in order to get the "rough answer" in unfinished form. It should still be mathematically correct but your teacher will likely have the finished form answer in the answerbook
- try to get the "rough form answer" first, then worry later about expanding the (squareroot + cubic root)3
- Mathematically it's not very significant - it's more of a style issue, I suppose.
(x-2)
3 = (2
0.5 + 2
2/3)
3
. In the end phase we must give the answer for the question "What does this clause yield: clause is; x
3 -6x
2 + 6x"
The answer must be another clause, which equals that quadratic clause. The full clause in the ending (both sides of equation) will be an equation, in that sense. So, therefore the ending clause should be properly balanced like all equations, if that makes it clear. This is my interpretation at least.
But the question asks simply (what does the left side clause give you, on the right side clause?)
- We know for a fact that this equation holds true
x=2 + √2 +
3√4
(x-2)
3 = [√2 +
3√4]
3 This equation must hold true as well (it f*****g should hold true!)
What does the clause X
3 -6X
2 +6X equal to?
Give the clause, which equals to that earlier clause. [ X
3 -6X
2 +6X ]
to-do-list
1. first equation was x= 2 + 2
0.5 + 2
2/3
2. in the first equation, minus 2 from both sides.
3. in the first equation, then cube both sides (third power both sides)
4. calculate the (x-2)
3 with Newton's binomial formula, or use the wikipedia article about binomial theorem, and find the formula for (x+y)
3. Use pen-and-paper and be careful with calculation!
5. according to my limited knowledge, you can substitute the negative sign, simply by using brackets and minus inside
(x-2)^3 = [x+(-2)] ^3
When you calculate
a+(-b)
it is the same as
a-b
At least I hope so because otherwise I screwed up my own solution hehe...
