Pool heat gain by solar radiation versus heat loss by evaporation

AI Thread Summary
The discussion centers on the effectiveness of using 22mm thick black EPE panels to cover a pool in relation to heat gain from solar radiation and heat loss from evaporation. It is noted that up to 85% of solar radiation can heat an uncovered pool, while evaporation accounts for 70% of heat loss. The key question raised is whether the heat gain reduction from covering the pool with EPE panels outweighs the benefits of reduced evaporation. One suggestion was to use a transparent foil cover, but concerns about its practicality were expressed. Ultimately, the user seeks clarity on the optimal approach for maintaining pool temperature on sunny days.
chrisDH
Messages
2
Reaction score
0
Hi,

On various websites I read that 70% of the heat loss of a pool is by evaporation, whereas up to 85% of the solar radiation can heat an uncovered pool.

We use 22mm thick black color EPE panels to cover our pool.
On a sunny day, is it better to cover the pool or to leave it uncovered ?

In other words ;
Is the reduction of heat gain (because of the EPE panel cover) compensated by the reduced heat loss by evaporation ?

Thanks for your help

Chris
 
Science news on Phys.org
How about using a transparent foil cover? It let's the sun in, and keeps the vapor inside.
 
Hi A.T

thanks, but I've had one of those before. there difficult to remove and you need an ugly big roll beside your pool.

Since I've been using the EPE panels my pool is a lot warmer too.
I just cannot figure out whether it's better to cover the pool during a sunny day or not

rgds

Chris
 
I need to calculate the amount of water condensed from a DX cooling coil per hour given the size of the expansion coil (the total condensing surface area), the incoming air temperature, the amount of air flow from the fan, the BTU capacity of the compressor and the incoming air humidity. There are lots of condenser calculators around but they all need the air flow and incoming and outgoing humidity and then give a total volume of condensed water but I need more than that. The size of the...
Thread 'Why work is PdV and not (P+dP)dV in an isothermal process?'
Let's say we have a cylinder of volume V1 with a frictionless movable piston and some gas trapped inside with pressure P1 and temperature T1. On top of the piston lay some small pebbles that add weight and essentially create the pressure P1. Also the system is inside a reservoir of water that keeps its temperature constant at T1. The system is in equilibrium at V1, P1, T1. Now let's say i put another very small pebble on top of the piston (0,00001kg) and after some seconds the system...
Back
Top