S- and P-Wave Cross Section Explained

[touqra]

What does it mean when they say s wave cross section, p wave cross section .. ?

 

[malawi_glenn]

What does it mean when they say s wave cross section, p wave cross section .. ?

the l-quantum number of the incoming wave. You often have a plane wave coming into the target. The plane wave you write as a linear combination of spherical waves, and you call this "Partial Wave expansion".

http://farside.ph.utexas.edu/teaching/qm/lectures/node70.html

The l that you see in eq 957 is then the "l - QM number".
And l is denoted by, 0 = s, 1 = p, 2 = d, etc, same as in atomic physics notation.

Semiclassicaly, you can see the l as the classical angular momenta of the incoming particle with respect to the centre of the scattering potential. And also the l is quantisized, so only some values of l are allowed.

Now since the sum goes to infinity in eq 957, we cut of where we expect no partial waves to contribute. And that is often assigned by l_{max} \approx R\cdot k
Where R is the range of the potential and k is the momenta of the incoming particle (wave number).

Now the cross section is proportional to the scattering amplitude modulus square, i.e the modulus square of eq. 965 times a constant with a lot of pi's hbar's etc.

So the s-cross section, you only have l = 0 in you sum, and p-cross section only l = 1. etc.

I hope you got the idea =)

 

[Smoochie]

Hello,
To munch the QM into an analogy:
Another way to look at is - how does one particle look to another. If you assume the target particle to be ball-like, then in its basic form (ground state), you'll get the classic 3D cross-section - this is how it will appear to the incoming particle and such it will be scattered from the target particle. But if the particle is excited to a higher state, then it will no longer appear as a ball but something else entirely. And vice versa.
Smoochie