Should I add an intercooler and EGR to my turbocharged gas engine?

  • Thread starter Thread starter autoingenes
  • Start date Start date
  • Tags Tags
    Engines Gas
AI Thread Summary
Adding an intercooler to a turbocharged natural gas engine may not significantly improve volumetric efficiency, as its primary function is to reduce the temperature of compressed air, enhancing air density and preventing excessive combustion temperatures. EGR systems can help lower combustion temperatures and emissions, but their effectiveness in increasing octane rating is questionable since natural gas already has a high octane rating. The discussion highlights the rarity of resources on turbocharging natural gas engines, making research challenging. Overall, the decision to add an intercooler or EGR should consider these factors and the specific goals for engine performance and emissions. Further research and data on their effects in turbocharged spark-ignition engines would be beneficial.
autoingenes
Messages
1
Reaction score
0
Hey Guys needed some advice related to Turbocharging of natural gas engines.
I'm working on turbocharging of gas engine for the first time and was trying to do some research on the same before jumping into the nitty gritty stuff. I Do not have much experience working with turbochargers. Turbo natural gas engine are very rare and its difficult to find any helpful material either.

I know that turbocharged diesel engines generally include intercoolers to further increase the volumetric efficiency. Since Natural gas engine have lower volumetric efficiency, will adding an intercooler have a quantifiable improvement on increasing the volumetric efficiency?

Also what are the pro and cons of adding an EGR to the mix?

Any links/papers describing the effect (good or bad) of adding an intercooler and/or EGR to a turbocharged SI engine will go a long way in helping me make up my mind.
 
Engineering news on Phys.org
Intercoolers are not there to improve the volumetric efficiency, per se. They are there to reduce the temperature of the compressed air to improve the air density and because charging the cylinders with heated air can produce excessive combustion temps and high EGTs.

EGR systems are there to make the gas behave like it has a higher octane rating and to reduce combustion temps in order to reduce pollution. Natural gas already has a very high octane rating, so it's questionable whether adding EGR would do much for octane. Not sure about the pollution part.
 
How did you find PF?: Via Google search Hi, I have a vessel I 3D printed to investigate single bubble rise. The vessel has a 4 mm gap separated by acrylic panels. This is essentially my viewing chamber where I can record the bubble motion. The vessel is open to atmosphere. The bubble generation mechanism is composed of a syringe pump and glass capillary tube (Internal Diameter of 0.45 mm). I connect a 1/4” air line hose from the syringe to the capillary The bubble is formed at the tip...
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'd like to create a thread with links to 3-D Printer resources, including printers and software package suggestions. My motivations are selfish, as I have a 3-D printed project that I'm working on, and I'd like to buy a simple printer and use low cost software to make the first prototype. There are some previous threads about 3-D printing like this: https://www.physicsforums.com/threads/are-3d-printers-easy-to-use-yet.917489/ but none that address the overall topic (unless I've missed...
Back
Top