Smaller droplet creation by ultrasonic humidifiers

AI Thread Summary
The discussion revolves around using an ultrasonic humidifier to create mist for a science project and the potential to reduce droplet size by modifying the water. The initial inquiry suggests that droplet size may be influenced by viscosity and surface tension. A participant suggests that adding surfactants, like soap, could decrease surface tension and thus reduce droplet size. However, another participant points out that many humidifier manuals caution against using soap, as it can alter surface tension to the extent that it inhibits mist production. This contradiction highlights the need for careful experimentation and consideration of the effects of additives on humidifier performance.
arnoke
Messages
8
Reaction score
0
Hi all,

For a science project, I'm using mist, created by an ultrasonic humidifier.
An ultrasonic humidifier uses a membrane that vibrates at ultrasonic frequency to disperse water into tiny droplets, resulting in a cool mist.

Now I was wondering; is there a way to reduce the droplet size by adding something to the water? I really don't know much about chemistry but I would guess the droplet size depends on the viscosity or maybe the surface tension of the fluid?

ps. The mist can be contained, and does not necessarily have to be used in an open room, so no health risks here.

Tnx a lot!
 
Chemistry news on Phys.org
Hi Arnoke! I don't know very much about the physics affecting droplet size, but I agree that surface tension is likely an important variable. I would expect decreasing surface tension to reduce the droplet size. Surfactants (such as soap or detergents) decrease water's surface tension, so I would try adding some of these to the water. Keep me posted on if that works or not!
 
Tnx for your response, ZacharyM.
I'll definitely test it, once I get hold of a new vaporizer (broke my old one :)).
The strange thing however, is that most manuals state that soap will indeed change the surface tension, stopping the vapor production as a result.
e.g. http://amasci.com/amateur/clouds.html :
"If you use soap to wash down the humidifier parts, rinse it very well afterwards. A small amount of soap in the water will change the surface tension and inhibit the mist production. If your device mysteriously stops making mist, try cleaning out the humidifier's water-pool section with non-soapy paper towels. As an experiment, drip some liquid soap into the operating humidifier to see what happens."
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...

Similar threads

Back
Top