Starting Vehicles: Gears Engaged or Not?

  • Thread starter Thread starter akhand121
  • Start date Start date
  • Tags Tags
    Vehicles
AI Thread Summary
Certain vehicles can be started with gears engaged, primarily those with manual transmissions, which allow for push starts. Automatic transmissions typically cannot be push started due to their reliance on engine power for gear engagement. Vehicles with electronic ignition systems may also fail to start if the battery is too weak, as they require sufficient power to operate. Some older GM transmissions had features that allowed for unique starting methods, but these are not common. Overall, manual transmissions are the most reliable for starting with gears engaged.
akhand121
Messages
1
Reaction score
0
certain vehicles can be started by keeping the gears engaged while certain others cannot...how ?
 
Engineering news on Phys.org
Specify which types of vehicle can be started with gears engaged.
 
akhand121 said:
certain vehicles can be started by keeping the gears engaged while certain others cannot...how ?

Are you referring to what is known as a "push start"? This is where you push the car to get it rolling and then engage the gears to crank the engine.

If so, this generally only works if you have a manual transmission. Automatic transmissions usually have a pump that is run off the engine. If the engine isn't already running, the transmission won't engage the gears and the car effectively stays in neutral.

Another reason that you might not be able to push start a car is if it has a electronic ignition system. If the battery is completely or nearly complete dead, it won't have enough juice to run the system and at the low speed the engine turns during a push start, the alternator won't either.
 
On automatic transmissions, you will have to have a "rear pump" driven by the output shaft.

Some GM transmission of the early 60s had what is called "grade retard" which was found in the dynaflow and turboglide.

Some versions had a rear pump.
 
I have a manual transmission. I have been able to move the unresponsive car by engaging lowest gear and operating the ignition and starter motor. Sometimes it then jumps to life, and one can carry on as if nothing had happened!
 
Thread 'Turbocharging carbureted petrol 2 stroke engines'
Hi everyone, online I ve seen some images about 2 stroke carbureted turbo (motorcycle derivation engine). Now.. In the past in this forum some members spoke about turbocharging 2 stroke but not in sufficient detail. The intake and the exhaust are open at the same time and there are no valves like a 4 stroke. But if you search online you can find carbureted 2stroke turbo sled or the Am6 turbo. The question is: Is really possible turbocharge a 2 stroke carburated(NOT EFI)petrol engine and...
I need some assistance with calculating hp requirements for moving a load. - The 4000lb load is resting on ball bearing rails so friction is effectively zero and will be covered by my added power contingencies. Load: 4000lbs Distance to travel: 10 meters. Time to Travel: 7.5 seconds Need to accelerate the load from a stop to a nominal speed then decelerate coming to a stop. My power delivery method will be a gearmotor driving a gear rack. - I suspect the pinion gear to be about 3-4in in...

Similar threads

Back
Top