Testing Transformer: What is the Top Metal Thing?

AI Thread Summary
The metal component on top of the testing transformer is identified as a corona ring, commonly made of hollow aluminum. Its primary function is to mitigate corona discharge, which occurs at high voltages starting around 1000V and becomes significant above 100KV due to voltage gradients at sharp edges. The rounded shape of the corona ring helps reduce ionization of air, preventing electrical discharge. The discussion also contrasts the corona ring's design with that of a lightning rod, which serves a different purpose. Understanding the role of the corona ring is essential for effective high-voltage equipment design.
eric336
Messages
11
Reaction score
0
Hi everyone.

What is the metal thing on the top of the testing transformer (figure below)? It looks like electrode, but what is the use? I find it ubiquitous in many HV equipments.

Ac_Test_System_Hctt_Test_Transformer.gif
 
Engineering news on Phys.org
Corona Ring.
Usually a hollow aluminum spinning.
 
At high voltages ( Starting around 1000V and becoming very pronounced > 100KV) the voltage gradient around sharp corners will cause the air to ionize, causing Corona. The rounded shapes help to reduce the effect. And to clarify CP's post, the aluminum is not spinning, that is the manufacturing process often used to make the ring. Google (as usual ) has some good info. - Also note how a lightning rod is physically the opposite.
 

Thread 'Underwater piezoelectric sensor array receive sensitivity'

Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
View full post »

Thread 'Question about bonding ground and neutral'

I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...
View full post »

Thread 'What happens if shielded cable has short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Similar threads

Earth Resistivity Test on concrete base
Replies
4
Views
1K
Partial Discharge Analysis for Transformer Insulation Testing
Replies
1
Views
1K
MMF diagrams of transformer construction options
Replies
9
Views
2K
How much bulge means a bad cap?
Replies
7
Views
3K
Why does the top surface of a Silicon Die measure close to 0 ohms?
Replies
5
Views
1K
What's the Athena (Silvaco) code for pyramid texturing on a solar cell?
Replies
10
Views
962
Open circuit test of 3 phase transformer in Ansys Maxwell
Replies
4
Views
5K
Figuring Out the Reactive Energy Measurement Method with Field & Lab Tests
Replies
2
Views
3K
Self excited induction generators and grid connected solar inverters?
Replies
9
Views
2K
Fried my power supply by doing a bad thing
Replies
36
Views
4K

Hot Threads

Recent Insights

Back
Top