Upgrade Your AC System with Hybrid Condensing Units | AEC.us.com

  • Thread starter Thread starter AECenter
  • Start date Start date
  • Tags Tags
    Units
AI Thread Summary
A new hybrid condensing unit designed for residential and small building applications claims to match the size of a 5-ton air-cooled system while facilitating up to 30 tons. This unit reportedly outperforms traditional air-cooled condensers in efficiency during high temperatures. However, questions remain about its performance during cooler periods and whether it maintains a fivefold efficiency advantage. The design features an air intake above a water reservoir, utilizing a mesh and coil system that can be sprayed with water to enhance cooling. The pump's operation is adjustable based on ambient conditions, offering flexibility in performance.
AECenter
Messages
13
Reaction score
0
I just found a manufacturer that makes a hybrid condensing unit that is roughly the same size as a 5-ton air-cooled one for residential and small building purposes, but it claims to be able to facilitate a 30-ton system.

The manufacturer says that it really beats the efficiency of an air-cooled condenser during the hotter parts of the day, obviously, but when it is night or cooler parts of the day, do hybrid condensers still perform 5x better than air cooled ones?


Thanks,
chris
aec.us.com
 
Engineering news on Phys.org
Here is the company's link. Hybrid meaning air-cooled / water-cooled unit.
http://thermalflow.net/

The units are about the size of a McDonnald trash can, have the air intake on the bottom above a water resevoir. The air comes in and moves through a mesh then passes around the coil. The coil and mesh can be sprayed with water from nozzles at the top of the unit, just below the fan that rejects the heated air.

The pump can either be on or off depending on the ambient air conditions.
 
Thread 'Physics of Stretch: What pressure does a band apply on a cylinder?'
Scenario 1 (figure 1) A continuous loop of elastic material is stretched around two metal bars. The top bar is attached to a load cell that reads force. The lower bar can be moved downwards to stretch the elastic material. The lower bar is moved downwards until the two bars are 1190mm apart, stretching the elastic material. The bars are 5mm thick, so the total internal loop length is 1200mm (1190mm + 5mm + 5mm). At this level of stretch, the load cell reads 45N tensile force. Key numbers...
I'm trying to decide what size and type of galvanized steel I need for 2 cantilever extensions. The cantilever is 5 ft. The space between the two cantilever arms is a 17 ft Gap the center 7 ft of the 17 ft Gap we'll need to Bear approximately 17,000 lb spread evenly from the front of the cantilever to the back of the cantilever over 5 ft. I will put support beams across these cantilever arms to support the load evenly
Back
Top