What are saturable absorbers and how do they impact the behavior of lasers?

  • Thread starter Thread starter AmyJ
  • Start date Start date
  • Tags Tags
    Laser
AI Thread Summary
Saturable absorbers are materials that decrease absorption with increasing light intensity, enabling passive Q-switching in lasers. They initially create high losses due to strong absorption, resulting in a slow buildup of intensity within the laser cavity. As intensity increases, the material becomes more transparent, leading to rapid intensity buildup and pulsed emission. Commonly used in Nd:YAG lasers, saturable absorbers allow for high repetition rates but cannot be externally triggered. This method is cost-effective for generating pulsed laser output.
AmyJ
Messages
5
Reaction score
0
I'm about to do some study on bifurcations and oscillations in lasers with saturable absorbers. however, my knowledge on lasers is fairly basic, so I'm not sure where to begin or find more information. If anyone could give me some advice, it would be very helpful :). What type of lasers usually have saturable absorbers and in what way do they differ from other lasers? :)
 
Science news on Phys.org
Saturable absorbers are a way to realize passive Q-switching. A saturable absorber is any material, which absorption decreases with increasing intensity of the incident light. How well high intensity builds up inside a cavity depends on its Q-factor. The fewer losses you have, the higher the Q-factor will be. If you are using saturable absorbers you usually have high losses (due to the strong absorption) at first. A weak lasing process happens, but the buildup of intensity inside the resonantor is rather slow. Nevertheless a lot of energy is stored in the gain medium as the pumping produces an inversion. As the intensity inside the cavity slowly increases, the material becomes more transparent and the losses go down. Stimulated emission is now very likely and the intensity builds up quickly. The losses are quite low, but the number of photons inside is so high that nevertheless a significant portion of the photons will be coupled out and emitted as a pulse. Now the intensity is lower again, the enrgy stored in the gain medium has been released in the lasing process, the absorption rises and the process begins again. So saturable absorbers are one way to produce pulsed emission. It is a rather cheap method and the repetition rates are quite high. One drawback is, that the pulses can't be triggered externally.

Saturable absorbers can be found quite frequently in Nd:Yag lasers.
 
Thank you. That is really helpful. Much appreciated :D
 
To repeat cthugha a bit:

For some general information on pretty much any laser subject i use this online encyclopedia. Has a decent article on saturable absorbers which you can take to branch off on pretty much any other laser subject.

http://www.rp-photonics.com/saturable_absorbers.html
 
Thread 'Simple math model for a Particle Image Velocimetry system'
Hello togehter, I am new to this forum and hope this post followed all the guidelines here (I tried to summarized my issue as clean as possible, two pictures are attached). I would appreciate every help: I am doing research on a Particle Image Velocimetry (PIV) system. For this I want to set a simple math model for the system. I hope you can help me out. Regarding this I have 2 main Questions. 1. I am trying to find a math model which is describing what is happening in a simple Particle...
Thread 'How to model converging illumination through object plane (in ZEMAX)'
Hello community, I'm designing a projection lens system for a 35mm film projector in Zemax OpticStudio and struggling with the correct sequential mode setup for the illumination geometry. The light source is a Xenon short-arc lamp reflected by an ellipsoid mirror, which creates a converging cone with a 40.6 degree full angle that passes through the film gate. The film gate is my object plane, but the light doesn't diverge from it like a typical Lambertian source. Instead, the converging...
Back
Top