What Are the Best Materials for Reflecting Low-Frequency Sound?

  • Thread starter Thread starter leka
  • Start date Start date
  • Tags Tags
    Control Noise
AI Thread Summary
Materials that effectively reflect low-frequency sound, particularly between 500Hz and 1KHz, are crucial for noise reduction in AC/Heating systems in airplanes. Active noise control methods, such as phase cancellation, are also relevant for this application. The discussion highlights the need for specific materials and design considerations for a muffler system. Participants are encouraged to share sources or insights related to noise reduction mechanisms. Understanding both material properties and active/passive noise control strategies is essential for achieving effective sound attenuation.
leka
Messages
20
Reaction score
0
Active/Passive noise control

hi everyone,
I am currently working on a project to reduce noise in AC/Heating systems in airplanes. As reference am using some literature in Engineering Noise Control and some research papers on Active/Passive noise control. I am currently searching for some information on; if there are materials that are good reflectors of sound at low frequencies, between 500Hz and 1KHz. The current aplication that have in mind calls for a sort of a muffler(closed ends pipe, from outside). Geometry and other parameters are not defined yet.
If anyone has any sources or knows any information related to mechanisms for noise reduction or have any ideas feel free to elaborate.

cheers
 
Engineering news on Phys.org
In your research you have probably already come across this, but I'll mention it just the same. Phase cancellation is an active form of noise reduction. You may want to check into that.
 

Thread 'Query on Isentropic relationships (such as PV^gamma = constant)'

Hi all, I have a question. So from the derivation of the Isentropic process relationship PV^gamma = constant, there is a step dW = PdV, which can only be said for quasi-equilibrium (or reversible) processes. As such I believe PV^gamma = constant (and the family of equations) should not be applicable to just adiabatic processes? Ie, it should be applicable only for adiabatic + reversible = isentropic processes? However, I've seen couple of online notes/books, and...
View full post »
Thread 'How can I find the cleanout for my building drain?'

Thread 'How can I find the cleanout for my building drain?'

I am a long distance truck driver, but I recently completed a plumbing program with Stratford Career Institute. In the chapter of my textbook Repairing DWV Systems, the author says that if there is a clog in the building drain, one can clear out the clog by using a snake augur or maybe some other type of tool into the cleanout for the building drain. The author said that the cleanout for the building drain is usually near the stack. I live in a duplex townhouse. Just out of curiosity, I...
View full post »

Thread 'Dry sump pump issue'

I have an engine that uses a dry sump oiling system. The oil collection pan has three AN fittings to use for scavenging. Two of the fittings are approximately on the same level, the third is about 1/2 to 3/4 inch higher than the other two. The system ran for years with no problem using a three stage pump (one pressure and two scavenge stages). The two scavenge stages were connected at times to any two of the three AN fittings on the tank. Recently I tried an upgrade to a four stage pump...
View full post »

Similar threads

Which Materials Reflect Low-Frequency Sound in AC/Heating Systems?
Replies
3
Views
5K
Generating Random High/Low Sounds Using PIC Controller?
Replies
4
Views
1K
How can I adjust the roll off of my preamp design for better frequency response?
Replies
3
Views
2K
Musical resonance of a cylinder/tube with a hole in the center
Replies
4
Views
2K
I Frequencies of standing waves in a straw
Replies
12
Views
5K
I Can a Single Speaker Effectively Direct Low Frequencies?
Replies
13
Views
2K
High-frequency (inaudible by humans) acoustic noise from stepper motor
Replies
3
Views
6K
Let's talk NVH/Exhaust acoustics tuning
Replies
7
Views
4K
How to Measure High and Low Impedance Accurately?
Replies
7
Views
3K
What is needed to allow sound to move an object
Replies
6
Views
2K

Hot Threads

Recent Insights

Back
Top