What is the Time Limit for Boarding the Bobbing Boat?

  • Thread starter Thread starter patricoles
  • Start date Start date
  • Tags Tags
    Boat Motion
AI Thread Summary
The discussion revolves around calculating the time limit for boarding a boat that is bobbing in simple harmonic motion. The boat has a mass of 1500 kg, an amplitude of 20 cm, and completes one cycle every 3.5 seconds. The individual, weighing 60 kg, will only board the boat when its deck is within 10 cm of the dock level. The calculations indicate that there is approximately 1.17 seconds available for boarding during each cycle when the boat is at the appropriate height. The accuracy of the calculations is confirmed, though some details were not fully shown.
patricoles
Messages
5
Reaction score
0

Homework Statement







Don’t Miss the Boat. While on a visit to Minnesota
(“Land of 10,000 Lakes”), you sign up to take an excursion around
one of the larger lakes. When you go to the dock where the 1500-
kg boat is tied, you find that the boat is bobbing up and down in the
waves, executing simple harmonic motion with amplitude 20 cm.
The boat takes 3.5 s to make one complete up-and-down cycle.
When the boat is at its highest point, its deck is at the same height
as the stationary dock. As you watch the boat bob up and down,
you (mass 60 kg) begin to feel a bit woozy, due in part to the previ
ous night’s dinner of lutefisk. As a result, you refuse to board the
boat unless the level of the boat’s deck is within 10 cm of the dock
level. How much time do you have to board the boat comfortably
during each cycle of up-and-down motion?



Homework Equations



ω : ω = 2π /T gives that x(t) = Acos(2π t/T)

The Attempt at a Solution



t = (T/2π )(1.047 rad) = (3.5 s/2π )(1.047 rad) = 0.583 s
2t = 2(0.583 s) =1.17 s.
 
Physics news on Phys.org
Did you have a question?
 
gneill said:
Did you have a question?

Yeah, Is my work correct?
 
patricoles said:
Yeah, Is my work correct?

Well, your answer appears to be correct. Whether or not your work is correct I cannot say, since you didn't show it all!
 
gneill said:
Well, your answer appears to be correct. Whether or not your work is correct I cannot say, since you didn't show it all!

oh well sorry about that...
 
I multiplied the values first without the error limit. Got 19.38. rounded it off to 2 significant figures since the given data has 2 significant figures. So = 19. For error I used the above formula. It comes out about 1.48. Now my question is. Should I write the answer as 19±1.5 (rounding 1.48 to 2 significant figures) OR should I write it as 19±1. So in short, should the error have same number of significant figures as the mean value or should it have the same number of decimal places as...
Thread 'A cylinder connected to a hanging mass'
Let's declare that for the cylinder, mass = M = 10 kg Radius = R = 4 m For the wall and the floor, Friction coeff = ##\mu## = 0.5 For the hanging mass, mass = m = 11 kg First, we divide the force according to their respective plane (x and y thing, correct me if I'm wrong) and according to which, cylinder or the hanging mass, they're working on. Force on the hanging mass $$mg - T = ma$$ Force(Cylinder) on y $$N_f + f_w - Mg = 0$$ Force(Cylinder) on x $$T + f_f - N_w = Ma$$ There's also...
Back
Top