What will be tension on string pulled by equal forces?

AI Thread Summary
Tension in a string pulled by equal but opposite forces is not zero, despite the net force being zero, due to the interactions at both ends of the string. According to Newton's third law, the forces acting on the string from both ends are not action-reaction pairs because they act on different bodies. When equal forces are applied, the string experiences tension as it stretches, even though its center of mass does not accelerate. In elementary physics, strings are often considered massless, leading to the assumption that tension is constant and equal to the applied forces. Thus, applying equal forces at different points can indeed create tension in the string.
aqdus
Messages
2
Reaction score
0
what will be tension on string pulled by equal but opposite forces?
 
Physics news on Phys.org
Newton's thirld law. If you pull a string fixed at the other end it will have the same tension as the if the string is pulled by equal but opposite forces.
 

Attachments

  • Snapshot.jpg
    Snapshot.jpg
    2.8 KB · Views: 718
  • Like
Likes aqdus
but in both cases there will be two but opposite forces on string so net force will be zero on string why the tension is not zero ?
 
When you draw a free body diagram be careful not draw both forces in a action-reaction pair. In a action-reaction pair the forces don't act on the same body. If you and I both pull the string with equal but opposite forces, I am the body which you apply force to and you are the body I apply force to. The sketch I made wasn't a FBD as it contained both forces.
 
The two forces acting at the two ends of the string are not an action-reaction pair. They correspond to two different interactions.
At one end (let's say where you pull by hand) there is the interaction hand-string. You pull with F1, the string pulls with -F1.
At the other end you have interaction between the string and wall and again you have F2 on the string and -F2 on the wall.

If the center of mass of the string does not accelerate, you will have F1=F2 (in magnitude) and the net force is zero. This does not prevent tensions developing in the string.
The fact that the net force is zero just tell you that the acceleration is zero. But they don't have to be equal.

Now, usually the string is assumed massless in elementary problems so even when we have acceleration the two forces are taken as equal. And the tension along the string is assumed to be constant and equal to either one of these forces.

So, to go back to the point, you can and many times do, create tension in a body by applying equal forces at different points of the body.
 
aqdus said:
but in both cases there will be two but opposite forces on string so net force will be zero on string why the tension is not zero ?

Do you really expect an elastic band not to stretch if you pull it from both ends? Its centre of mass won't move because there is no nett force, but it's certainly going to stretch.
 
I have recently been really interested in the derivation of Hamiltons Principle. On my research I found that with the term ##m \cdot \frac{d}{dt} (\frac{dr}{dt} \cdot \delta r) = 0## (1) one may derivate ##\delta \int (T - V) dt = 0## (2). The derivation itself I understood quiet good, but what I don't understand is where the equation (1) came from, because in my research it was just given and not derived from anywhere. Does anybody know where (1) comes from or why from it the...
Back
Top