Has path of a standing wave confined in a metal box been measured and described?

AI Thread Summary
The discussion centers on the measurement and description of standing waves confined within a rectangular metal box. It is confirmed that this is a well-studied phenomenon, particularly in the context of microwave cavities, which have numerous applications. The mathematical representation of standing waves is clarified, emphasizing that they do not oscillate back and forth but remain stationary in their defined patterns. For further reading, textbooks on microwave cavities are recommended as valuable resources. Understanding the behavior of standing waves in such environments is crucial for various technological applications.
bentlight
Messages
1
Reaction score
0
Has path of a standing wave confined inside a metal box been measured and described?

I'm thinking path is circular, or, oscillates/bounces back and forth like a pendulum.

I'm thinking of a standing wave moving inside a metal rectangular box.

Has the path of a standing wave inside a rectangular metal box ever been measured and described?

Where can I read this description?

Thanks, bentlight
 
Engineering news on Phys.org
Find a textbook with a description of microwave cavities.

And yes, this is a very well-studied problem (cavities are used in LOTS of applications, especially in microwave systems); and for rectangular cavities (=boxes) the math is actually quite easy.
 
In addition to f95toli: a standing wave stands. No back and forth movements. It's like cos(wt)*cos (pi*x/X)*cos (pi*y/Y)*cos(pi*z/Z), if needed with higher modes.
 
Hi all I have some confusion about piezoelectrical sensors combination. If i have three acoustic piezoelectrical sensors (with same receive sensitivity in dB ref V/1uPa) placed at specific distance, these sensors receive acoustic signal from a sound source placed at far field distance (Plane Wave) and from broadside. I receive output of these sensors through individual preamplifiers, add them through hardware like summer circuit adder or in software after digitization and in this way got an...
I have recently moved into a new (rather ancient) house and had a few trips of my Residual Current breaker. I dug out my old Socket tester which tell me the three pins are correct. But then the Red warning light tells me my socket(s) fail the loop test. I never had this before but my last house had an overhead supply with no Earth from the company. The tester said "get this checked" and the man said the (high but not ridiculous) earth resistance was acceptable. I stuck a new copper earth...
I am not an electrical engineering student, but a lowly apprentice electrician. I learn both on the job and also take classes for my apprenticeship. I recently wired my first transformer and I understand that the neutral and ground are bonded together in the transformer or in the service. What I don't understand is, if the neutral is a current carrying conductor, which is then bonded to the ground conductor, why does current only flow back to its source and not on the ground path...

Similar threads

Back
Top