Stopping discharging a battery during charging

  • Thread starter Thread starter adilsyyed
  • Start date Start date
  • Tags Tags
    Battery Charging
AI Thread Summary
To manage a lead acid battery-powered light during frequent power outages, a relay can be used to automatically turn off the light when charging begins. This setup requires a "break-before-make" relay to ensure the light disconnects from the battery when the charger is engaged. The relay should be powered by the wall outlet, allowing it to switch between configurations for charging and discharging. Users are encouraged to research relays further to understand their operation better. This solution provides a practical way to maintain light during outages while preventing battery discharge during charging.
adilsyyed
Messages
26
Reaction score
0
I am from a country where power outage is very common.
I have a light source which is run by a lead acid battery. At night, I want to keep this light ON during power outage and when the electricity is back on, the charging circuit engages and the lights should turn off itself.
I am guessing an arrangement would be needed so that when the charging starts, with it somehow, a circuit should sense it and open/dis-engage the discharging circuit.

Simple Version:
I want to plug the charger in the battery, during power outage the light will be ON and with power on (when the charger starts charging the battery), the light turns OFF.
 
Engineering news on Phys.org
adilsyyed said:
I am from a country where power outage is very common.
I have a light source which is run by a lead acid battery. At night, I want to keep this light ON during power outage and when the electricity is back on, the charging circuit engages and the lights should turn off itself.
I am guessing an arrangement would be needed so that when the charging starts, with it somehow, a circuit should sense it and open/dis-engage the discharging circuit.

Simple Version:
I want to plug the charger in the battery, during power outage the light will be ON and with power on (when the charger starts charging the battery), the light turns OFF.

I would use a relay powered from the wall power. You can connect your light and charging circuit to different parts of the relay to give the two different configurations.
 
berkeman said:
I would use a relay powered from the wall power. You can connect your light and charging circuit to different parts of the relay to give the two different configurations.

ummm... That would be a nice way to do it.
 
Be sure to use a "break-before-make" type of relay. :smile:
 
berkeman said:
Be sure to use a "break-before-make" type of relay. :smile:

If only I was expert in electronics.
But thanks for the head start, that's how we learn. I am going to read more about the relay you proposed.
 
Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...

Similar threads

Back
Top