Eddy Current Questions | Refresh Understanding

AI Thread Summary
Eddy currents are generated in conductive materials when exposed to a changing magnetic field. Not all metals exhibit significant eddy currents; ferrous materials are preferred for induction cooktops due to their higher magnetic permeability. The heat produced by eddy currents is influenced by both the material's resistivity and the strength of the current. Metal detectors utilize the principle of eddy currents to detect metallic objects. Overall, understanding eddy currents involves recognizing the relationship between magnetic fields, material properties, and induced currents.
likephysics
Messages
638
Reaction score
4
Need to refresh my understanding on eddy current.
Does every metal exhibit eddy current when it comes across a Mag field?
If this is the case, then why do induction cook tops required ferrous utensils.
A Metal detector also works on the principle of eddy current. correct?
 
Engineering news on Phys.org
There is quite a lot online about eddy currents, have you tried looking it up?
1. yes - provided the B-field changes
2. the heat depends on resistivity as well as current
3. yes - amongst others
 

Thread 'How might electronics be different if AC voltage was 72V at 45 Hz?'

Hey guys. I have a question related to electricity and alternating current. Say an alien fictional society developed electricity, and settled on a standard like 73V AC current at 46 Hz. How would appliances be designed, and what impact would the lower frequency and voltage have on transformers, wiring, TVs, computers, LEDs, motors, and heating, assuming the laws of physics and technology are the same as on Earth?
View full post »

Thread 'What happens if shielded cable has a short to the shield?'

While I was rolling out a shielded cable, a though came to my mind - what happens to the current flow in the cable if there came a short between the wire and the shield in both ends of the cable? For simplicity, lets assume a 1-wire copper wire wrapped in an aluminum shield. The wire and the shield has the same cross section area. There are insulating material between them, and in both ends there is a short between them. My first thought, the total resistance of the cable would be reduced...
View full post »

Thread 'Why does the amperage go real high if there is a low voltage short?'

I used to be an HVAC technician. One time I had a service call in which there was no power to the thermostat. The thermostat did not have power because the fuse in the air handler was blown. The fuse in the air handler was blown because there was a low voltage short. The rubber coating on one of the thermostat wires was chewed off by a rodent. The exposed metal in the thermostat wire was touching the metal cabinet of the air handler. This was a low voltage short. This low voltage...
View full post »

Similar threads

A Question on Skin Effect and Eddy Currents
Replies
6
Views
2K
Canned motor design rotor magnetics
Replies
3
Views
1K
Eddy currents in case of synchronous and asynchronous motors
Replies
14
Views
4K
Asking a question about eddy currents
Replies
1
Views
1K
Magnetic levitation using eddy current
Replies
10
Views
6K
Eddy Current brakes operating at high speeds
Replies
5
Views
3K
How does an eddy current brake work exactly?
Replies
2
Views
2K
Eddy current losses in core of a electromagnetic motor
Replies
41
Views
8K
I Why does metal moving though a magnetic field slow down?
Replies
17
Views
4K
Is Induction Heating More Efficient Than Resistive Heating for Water?
Replies
5
Views
4K

Hot Threads

Recent Insights

Back
Top