Condensation Polymers: Comparing A & B

AI Thread Summary
The discussion revolves around the properties of two condensation polymers: one made from ethylene glycol and terephthalic acid, and the other from glycerol and terephthalic acid. Key points include the assessment of polymer strength, flexibility, hydrogen bonding, and melting points. The first polymer is questioned for its potential weakness, with suggestions that its structure may influence this property. Flexibility is linked to the type of polymer, with atactic structures generally being more flexible. The strength of hydrogen bonds is debated, with clarification needed on how alternating R groups affect bonding. Lastly, it is noted that both polymers have similar molecular weights, implying that differences in properties may arise from structural efficiency in hydrogen bonding rather than molecular weight alone.
yu
Messages
1
Reaction score
0
Can someone please help me with this question? Thanx
Choose those statements that are correct about the following two condensation polymers:

(A) Prepared from ethylene glycol and terephthalic acid
and
(B) Prepared from glycerol (CH2OHCHOHCH2OH) and terephthalic acid

Both polymers have about the same molecular weight.
a) polymer (A) would be predicted to be weaker

b) polymer (A) would be predicted to be more flexible

c) Both polymers are attracted to each other by strong hydrogen bonds

d) polymer (A) would be predicted to have the higher melting point
 
Chemistry news on Phys.org
The question is pretty standard.

a) not sure what they mean by "weaker," perhaps something in relevance to bullet proof glass. In this case, you need to determine if the polymer belongs to syndatic, atactic, etc...(should find it in your text).

b)I believe it is atatic polymers which exhibit such flexibility as rubber, although I'm not absolutely sure of this.

c)A polymer with alternating R groups would have the stronger hydrogen bond. This question is worded rather poorly, not very clear, since hydrogen bonds are strong to begin with.

d)both polymers have the same molecular weight and thus if there are any differences in this factor it is due to the effeciency of hydrogen bonding due to structure.
 
I want to test a humidity sensor with one or more saturated salt solutions. The table salt that I have on hand contains one of two anticaking agents, calcium silicate or sodium aluminosilicate. Will the presence of either of these additives (or iodine for that matter) significantly affect the equilibrium humidity? I searched and all the how-to-do-it guides did not address this question. One research paper I found reported that at 1.5% w/w calcium silicate increased the deliquescent point by...
I was introduced to the Octet Rule recently and make me wonder, why does 8 valence electrons or a full p orbital always make an element inert? What is so special with a full p orbital? Like take Calcium for an example, its outer orbital is filled but its only the s orbital thats filled so its still reactive not so much as the Alkaline metals but still pretty reactive. Can someone explain it to me? Thanks!!
I'm trying to find a cheap DIY method to etch holes of various shapes through 0.3mm Aluminium sheet using 5-10% Sodium Hydroxide. The idea is to apply a resist to the Aluminium then selectively ablate it off using a diode laser cutter and then dissolve away the Aluminium using Sodium Hydroxide. By cheap I mean resists costing say £20 in small quantities. The Internet has suggested various resists to try including... Enamel paint (only survived seconds in the NaOH!) Acrylic paint (only...
Back
Top